CityCoco Start/Stop push button, 72V alarm system, USB charger, Carbon and other modifications

It's all about this little guy CityCoco. There are some changes and improvements made. It has a 72V Security Alarm system installed and I will guide you on how it works and how to program alarm sensitivity. Also, I will show you some citycoco tuning aka styling, so keep watching it is gonna be interesting! ;)
All the parts I installed you will find here - melderis.com/p...
If you have any questions or suggestions leave them down below in the comment section!
--------------------------------------------------------------------
🅢🅤🅑🅢🅒🅡🅘🅑🅔 - www.youtube.co...
Instagram - / uldismelderis
--------------------------------------------------------------------
Official Store ► melderis.com
--------------------------------------------------------------------
Song: Waesto - Twilight
Music provided by Vlog No Copyright Music.
Video Link: bit.ly/3KETcUL
#CityCoco #fatbike #alarm #startstop

[@TiwIzzy-s8j]

Hi uldis I need help with mine.where r u located thx

[@kamillapaj87]

Hello , interesting modifications 😀
I am trying to install this alarm with wheal lock on my scooter , but unfortunetly in my scooter i dont chawe this big 3 pin plug in my controller , did you have it in your controller or you soldered some additional wires to make it work ? :D

[@UldisMelderis]

Hi and thanks. Like I said in the video in my case it was simple plug and play. All I needed is just to find both of the plugs in that spaghetti wire loom. Both of plugs was free not connected, but take a look at your existing on/off switch as it might be used in your specific situation. Hope that helps! Post back how it will end for you. 😉

[@kamillapaj87]

@@UldisMelderis i have this alarm installed for few months now , I just had to soldered it to the correct cables in my scooter , it cuts the power so I cant power it on when its armed and I think its exactly same one like yours , but my alarm dont work with wheel lock because there is no plug for it originally , butni might fugured it out , I watched other guy taking apart controller in same scooter like yours and I seen where cables from that 3 pin plug goes inside the controller , so I might do it in a spare time

[@UldisMelderis]

How many wires come out from your one? I have this exact one - melderis.com/product/36v-72v-citycoco-alarm-with-start-stop-push-button/ White plug with 2 wires I think was just to power it up. A white plug with 3 wires is the one that will power it up and block the wheel. The black plug is just a start/stop button connection and the extra one wire is the antenna. @@kamillapaj87

[@kamillapaj87]

My alarm have 5 cables in total + antena so 6
3 cables in big plug that goes inside the controller and 2 wires in small plug that supposed to connect to wiring to cut power

[@UldisMelderis]

I think you are mistaken here, If I remember correctly white plug with 2 wires is the one that powers up the alarm and probably is enough to let you start the scooter. And 3 wire plug is feeding back juice to power up citycoco when the alarm goes nuts and blocks the motor. It was some time ago when I was fiddling around and currently have no time to go and confirm my theory... But I think it was that way at least in my situation. ;)
@@kamillapaj87