That looks great Mario! Just watching your arm/hand movements spraying in like watching a machine! I’ve got a black 2016 GMC Sierra, want to blackout the bumpers, grille and emblems. Think I’ll start out small a do the emblems first. Thanks for such a great and informative video! You’re a good man!
Looks good to me. About to do the grill and bumpers on my 2017 F250. Too much chrome for me. Helpful tip... use tire shine on your plastic trim pieces (bed rails, bumper, front spoiler, ect...) it makes them shine like new again. I always do that after I clean my truck.
That looks great Mario! Just watching your arm/hand movements spraying in like watching a machine! I’ve got a black 2016 GMC Sierra, want to blackout the bumpers, grille and emblems. Think I’ll start out small a do the emblems first. Thanks for such a great and informative video! You’re a good man!
Adhesive removal quick and easy for that glue 💯 great video
My brother mario keep up the content carnal its your boy nano 🔥
Amazing, looks damn good fam!
Thanks.
I think if you spray a cpl coats of clear high temp engine enamel on it will keep the heat from peeling it.
Looks good to me. About to do the grill and bumpers on my 2017 F250. Too much chrome for me. Helpful tip... use tire shine on your plastic trim pieces (bed rails, bumper, front spoiler, ect...) it makes them shine like new again. I always do that after I clean my truck.
Thanks for the advice 👍
No problem!
Did the sensors still work?
Yes sensors still work perfectly.
ok...that was my question. Thank you
Looks good. Next time try using fishing line to remove the badges👍
Sprayed right over your sensors?
Yes.
looks great
Looks good man,did you smoke out your taillights or where did you get them from?
There tail light covers and I bough them at amazon.
Looks real good bro
Great Vid! Get some ceramic coating for the rear bumper plastic molding
You should have done 5-6 coats bro. But nonetheless it looks great!! Great video
Not bad did you send it first
I actually didn't sand it I just cleaned it with thinner.
@@lifted_mario8071 k nice job
Thanks
@@lifted_mario8071 yw
How long did the plasti last.. is it still on there? I have the same truck
It's still in there driver side its starting to peel a little.
How many cans of each did it take?? I’m doing the same to my truck
I bought two of each but only used 1 and half of the other and only used 1 clear.
Bro I seen yo blacked out truck and I just had to subscribe
Thanks.
great job! how did it hold up?
It starting to peel on the passenger side by where the exhaust is.
Has it started peeling off yet
It actually has on the passenger side where the exhaust is.
Bumper's clean bro try 2+2 next time
Thanks
You must have plenty of money! Doing that to a 80,000 dollar truck. Got more money you got sense!!!!!
It's gonna peal off after a while
Get a Magic Wheel next time. Thank me later
🤙🤙
No cuema cuhhhh
Exclusive? Pindiho
Exclusive Taste truck n car club.