Looks like the float is stuck or the needle is stuck in the seat. Take it apart and clean it or could be the float level adjustment. I just realized how long ago this was haha
Boa noite quantos mm mede o carburador da Titan 150 e 26mm ou 24mm tenho uma fan 2007 ela tá com comando bravo e carburador original dela mesmo com um gicle de 100 de alta reaberto um pouco queria mas final ela da 125km a 130km a favor do vento qual carburador carburador fica melhor o da Titan 150 ou ou um pz26 o carburador original dela mesmo prende muito de final
@@buddhaboy2188most small engine floats don't have an adjustment try tapping on the card with a screw driver to dislodge the needle or clear whatever is holding it open
I mean if you left the bike sitting for a while with gas still in the carb bowl it would gum up and seize the float needle in place.. just clean things up maybe blow compressed air through all the orifices should work 🤷🏻♂️ but if it still pisses gas on the ground just adjust the float level slightly lower so it closes up sooner or replace the float needle and the float needle seat
Hey, i also have same issue in carburetor causes outlet flow of fuel gets leak everytime you run the engine... i had cleaned carburetor, checked fuel mixture, no issue in vavle...😢 unable to understand what to do ..i have euro 2 engine bike with keihin carburetor. Any suggestions will be a great help. Thanks🎉
I looked this problem up and found this video. Thanks for posting. With the advice of other commenters, I was able to fix it with a mallet. 😇
Looks like the float is stuck or the needle is stuck in the seat. Take it apart and clean it or could be the float level adjustment. I just realized how long ago this was haha
Could you help me
I’m having the same problem
Thanks. Your comment was very helpful
It seems like it's leaking from the sides not an over flow problem.😅
I watched a video and where the gas’s is leaking there is a bolt under the carburetor un tighten it and blow compressed air up where it leaks
overlow either due to rich mixture and damaged floater valve
damn leakin in three spots,i think its time for a new carb
Nope
Boa noite quantos mm mede o carburador da Titan 150 e 26mm ou 24mm tenho uma fan 2007 ela tá com comando bravo e carburador original dela mesmo com um gicle de 100 de alta reaberto um pouco queria mas final ela da 125km a 130km a favor do vento qual carburador carburador fica melhor o da Titan 150 ou ou um pz26 o carburador original dela mesmo prende muito de final
What is this bike?
It needs a float bowl adjustment or maybe it’s stuck
How much cc bike is this ?
rap it ,,end heavy screwdriver/ or bowl needs bent to level it off.. SET it ! floats
😮
F it....... send it!!! 😂
Gas is too expensive for that 😅
back in 2018 it wasn’t
Could be a bad or damage seal or float levels too high
I’m having the same problem fuel just keeps coming out of every little hole how do I adjust the float level .
@@buddhaboy2188most small engine floats don't have an adjustment try tapping on the card with a screw driver to dislodge the needle or clear whatever is holding it open
I mean if you left the bike sitting for a while with gas still in the carb bowl
it would gum up and seize the float needle in place.. just clean things up maybe blow compressed air through all the orifices should work 🤷🏻♂️
but if it still pisses gas on the ground
just adjust the float level slightly lower so it closes up sooner
or replace the float needle and the float needle seat
Hey, i also have same issue in carburetor causes outlet flow of fuel gets leak everytime you run the engine... i had cleaned carburetor, checked fuel mixture, no issue in vavle...😢 unable to understand what to do ..i have euro 2 engine bike with keihin carburetor. Any suggestions will be a great help. Thanks🎉
😂
Uuuuuuhhhhh. Id shut that off😅
Buy new carbeurator if it is more than 10 years old
Float needs adjusted letting in too much, that’s an overflow