HELLO: a question: the AOT-IGF Software can be installed on a PC to be used as a CAM? That is, someone can make NC Programs on a PC and then take them to the OKUMA Machine? Thanks
If the two grooves are identical but with different locations, using the final dialog block in the groove cycle allows you to specify the number of features to make, and their spacing
There is no provision to see both spindles at the same time. You can, however, switch back and forth between the two with the "mode select" switch in graphics, or the SP1-SP2 switch in process verify
I am having an issue too with it say multi cycle width a side 13ffb was wondering if I could get some help with that
HELLO: a question: the AOT-IGF Software can be installed on a PC to be used as a CAM? That is, someone can make NC Programs on a PC and then take them to the OKUMA Machine? Thanks
Hi I was wondering if you have to make 2 grooves out of that how would you space that out
If the two grooves are identical but with different locations, using the final dialog block in the groove cycle allows you to specify the number of features to make, and their spacing
How can you show AOT both graphics from first spindle and second spindle as the programs is running..
Thank you
There is no provision to see both spindles at the same time. You can, however, switch back and forth between the two with the "mode select" switch in graphics, or the SP1-SP2 switch in process verify