Coolice Charge Case's and Power Supplies Quad ISDT Q8 Compact

Afternoon All.
Following on from a previous quad ISDT Q8 case build, I was eager to try another but with a marginally larger case. So when AndyK said to me he wanted to move his four Q8's into a smaller case, it gave me the perfect opportunity to make the design I had on file into reality.
This video shows Andys blue case build, but the end photos show an orange DIY kit I made up to send to Sean and followed the same design, but featured charge port holders for SupraX S7 connectors I think they are.
Sean feed back to me that he could feel heat build up within the case, which was something I was expecting to be told.
So with Andys here which I was building I designed and printed a duct setup to take the PSU's hot exhaust air and direct it out the side of the case. A 3D printed grill on the outside adds the finishing touch.
This would cure the excess heat build up within the case, so I sent the files to Sean so he could 3D print them and retrofit into his case build and the feedback proved I'd fixed the potential problem.
Subsequent case builds from me employs this PSU exhaust setup.
Thanks for watching.
Ian Contessa
www.coolice.co.uk