How To Build A Smoker Trailer: Placing Rear Crossmembers On The Trailer Frame Part 3

In this video I show you how I notch and install the rear cross member.
Important Notes:
• Normally I would use all 2"x4" by 11 gauge or heavier rectangle tubing for a trailer build like this. I had to substitute material due to my supplier's stock.
• The trailer in this video is being framed in the upside down position. I prefer building them this way because I can hand the tongue and the axle hangers easier and more accurately, which will be explained in future videos.
• Fabrication Note- When fitting materials such as angle, channel, tube, etc., always leave a small gap in the fit up. This is especially important on a structural joint. Originally I caught a lot of hate on the social media reels for this particular clip because I said "perfect fit". I should have elaborated that this is not finish carpentry. For a weld to be structurally sound it must have full penetration. the best way to ensure that with these types of material is to allow a gap. On thicker material you'll see a "bevel" that flows into a "land" and then the gap. Thin materials like this 11 gauge tube, there isn't enough thickness to bevel and land.
• One more thing- You can also make a template using cardboard or another chunk of channel for this kind of fit-up. As a buddy of mine once said: "Everybody likes their hot dog a different way"...
By the way, I have several sets of DIY plans available for smoker trailers on my website:
Click here: smokerplans.net/collections/t...
_____________________________________________________________
In case you missed the first video where we got our environment set up and everything leveled, here's a link to it:
• How To Build A Smoker ...
Here's a couple links for stuff I'm using in this video series:
For the laser level here's a whole bunch of options on amazon:
amzn.to/3HstdP9
Here's a link for the one at harbor freight:
www.harborfreight.com/30-ft-s...
Here's a link for pipe stands on amazon:
amzn.to/48IFCuu
Get the trailer plans I mention in the video at smokerplans.net.
By the way, if you would like some plans or designs to build your own smoker, I have a few options for you!
here's some options:
1- Grab a FREE Set of Reverse Flow Smoker Plans for a 24 diameter by 48 inch long cooking chamber! Just pay the $12.95 S&H and I will send them right to your door!
Click here to grab your FREE Copy!
sbmfg.net/free-rf-smoker-plan
2- Grab your FREE Copy of these 250 Gallon Offset Smoker Plans for a propane tank! Same thing here, just pay the $12.95 S&H and I will send them right to your door!
Click here to grab your FREE Copy!
www.smokerplans.com/sb-legacy...
3- If you would like a bigger or a smaller smoker then visit our website to scroll through over 200 other smoker plans and designs that will show you everything you need to know to build your own dream smoker!
Click Here to visit our website!
smokerplans.net
4- Join our private online community full of guys just lik,e you that are building smokers and learning our process for designing and building smokers!
We also have online courses in the works!
Click here to learn more!
smokerbuilderu.com
Like I said, please like this video and subscribe to this channel so you don't miss a thing!
#offsetsmoker #propanetank #builtnotbought