Thank you for the tutorial, great help! Would you by any chance have or do a video with workflow of manual surfacing with geomagic wrap? Can not find it in your videos and could use some help :-)
I normally create patch layout using contour tracing for auto generation and clean up patches afterwards and was curious if you had some insight to an issue I come across sometimes - when using the repair patch/ delete and fill command sometimes it creates an unconnected patch and for the life of me have never been able to find a way to delete it without going into the "draw patch layout" command which in turn doesn't allow you to extend contours and causes more work. curious if you know of a way to deleting stray patches without having to go in to "draw patch layout" ?
@@gregoree197878 thanks for replying, yeah its happened a couple of times usually in very dodgy areas where it was too complicated for the software to deal with so it gives you these crazy patch sections which I usually just delete in the repair command and shuffle them to create a better patch network. I normally just delete the stray patches after surface fitment is complete but thought maybe there was a command that would allow me to do it in the editing phase, thanks again though!
Sir , this is very helpful! and its goog lecture vedio.
Great work on the VW part!
Great job, this was very helpful!
Thank you for the tutorial, great help! Would you by any chance have or do a video with workflow of manual surfacing with geomagic wrap? Can not find it in your videos and could use some help :-)
can i get the original scan file ( so i can follow the tutorial step by step plis )
Thank you.
awsome thank you
I normally create patch layout using contour tracing for auto generation and clean up patches afterwards and was curious if you had some insight to an issue I come across sometimes - when using the repair patch/ delete and fill command sometimes it creates an unconnected patch and for the life of me have never been able to find a way to delete it without going into the "draw patch layout" command which in turn doesn't allow you to extend contours and causes more work. curious if you know of a way to deleting stray patches without having to go in to "draw patch layout" ?
I think that is a bug you are seeing. I don't have a way around it at the moment.
@@gregoree197878 thanks for replying, yeah its happened a couple of times usually in very dodgy areas where it was too complicated for the software to deal with so it gives you these crazy patch sections which I usually just delete in the repair command and shuffle them to create a better patch network. I normally just delete the stray patches after surface fitment is complete but thought maybe there was a command that would allow me to do it in the editing phase, thanks again though!