Calculate the Specific injection Pressure & L/D Ratio
HTML-код
- Опубликовано: 16 сен 2024
- This video shows you how to calculate the specific pressure in injection molding. There are 3 examples in the video.
Hydraulic Cylinder = Hydraulic
Screw Tip = Specific
Mold Cavity = Cavity Pressure
Also, I go over L/D ratio.
Thanks for the support & please LIKE, SHARE, & SUBSCRIBE
Super good sir
Thanks for watching & the support to the channel I greatly appreciate it.
do you have calculation for injection pressure for plastic extrusion without piston actuator?
NO, but I can look into it for you if you would like me too. Thanks for watching & the support to the channel.
@@injectionmoldingskillsmore1064 yes please, thank you sir, i strugle to find injection pressure for my plastic extrusion for my school project
Hello, can you tel us, how to calculate the required injection pressure based on the volume or area of cavity and the material (plastic) to be injected?
I will see what I can do I just moved from Florida to Texas so give me some time. Thanks for watching & the support to the channel I greatly appreciate it.
I'm kinda new with working in molding been a cpl years. I'm getting splay near the gates and was wondering what changes wld you do to correct this? Wld it be cavity pressure?
You can play around with the speeds on injection. What its called is gate blush or gate sheer. They way to fix is to open the gate up a little or change the injection rate & mold temps. I hope this helps. Thanks for watching & the support.