Who ever has that problem where the atv starts full throttle, unscrew the throttle cable from the carb, and the barrel that goes in it, screw it in clockwise until the barrel drops and you can't see it, you seeing the top of the barrel doesn't count just make sure it's in all the way
Does anyone have a close up video, pictures or diagram of which hose goes from petcock to carb? Took mine off and forgot to get photo before and can’t remember which hose connects where on petcock and carb. Checked service manual and it doesn’t show connections.
Hey i just buy one like it and m not sure if. Need to mix my gas with 2 cycle oil on this? Or i just put straigrh gas in it??? And also it will cut off if i close the choke? Any ideas???
I have an lt80 and the oil injector always gums up the carburetor so I bought a block off plate for the oil injector and started putting pre mixed fuel in it
Hello someone please help I took that hose off at 4.28 mark but can't figure where does that hose go cause it fell out i know it goes to the carburetor in one side but where is it attached to
My 87 only had an idle screw. But it was clogged with dirt from a torn boot gone un noticed for years. I replaced it with a cheap carb from eBay. Its an exact clone of the stock mikuni but it has the air screw and runs perfect. Only needed slight adjusting
Hey do you think you could send me a fuel line configuration or explain it to me. my just flooded the case last time ive tried and I just let it set after draining about to try again.
use premix and empty to oil injector tank its better to mix than take the chance of running it dry. you can leave it all attached I don't trust mine or any injectors for oil. id rather be safe than sorry I need a new topend.
Alright, So one should be capped off its a vacume line, The line in the back is the vaccum line the line that is directly under the shutoff lever is the one that should run to the carb
More than likely your throttle slide is in wrong, it should go all the way down in there, The throttle slide cable has a slot that some people mistake as where the idle mix screw is supposed to be just keep moving it in different positions until it goes all the way down
Who ever has that problem where the atv starts full throttle, unscrew the throttle cable from the carb, and the barrel that goes in it, screw it in clockwise until the barrel drops and you can't see it, you seeing the top of the barrel doesn't count just make sure it's in all the way
Can you explain further on this I have a jr85 dirtbike that starts full throttle and I’m trying to fix it
you are the real mvp!!! Now i dont have to take it to the shop and give my money away. Thank you for the video
This helped a lot on my KFX 80. Thank You!
i realize I am kinda off topic but do anybody know a good place to stream new series online ?
@Devon Merrick Flixportal
@Zachary Gabriel thank you, I signed up and it seems to work :) Appreciate it!
@Devon Merrick You are welcome :D
Hello friend, thank you for your video, can you please explain to me where each of the hoses that go to the carburetor come from, please?
Ssme here! I only know the big brass one is fuel and the small brass one is oil. Not sure about the other two though.
Thank you sir great video, it helped me a lot
Anything special on connecting the throttle cable and spring back to carb???
life saver!! thanks
Does anyone have a close up video, pictures or diagram of which hose goes from petcock to carb? Took mine off and forgot to get photo before and can’t remember which hose connects where on petcock and carb. Checked service manual and it doesn’t show connections.
Thank you thank you thank you soooooo much ❤
1987 LT80 running like new still :) thanks!
Thank you
Thank you good sir
Hey i just buy one like it and m not sure if. Need to mix my gas with 2 cycle oil on this? Or i just put straigrh gas in it??? And also it will cut off if i close the choke? Any ideas???
Excellent and very informative video my friend.... thanks
I got an lt80 and I folloq these instructions but I can't get the throttle cable to come out the carb on the top
Thanks this video really helped me!
I have an lt80 and the oil injector always gums up the carburetor so I bought a block off plate for the oil injector and started putting pre mixed fuel in it
MCFINIGIN what ratio mix do you use? And what kind of 2 stroke oil you use?
@@valentinreyna-rosas3062 i put 32:1 In mine, Oil is some supertech 2 cycle found at walmart only smokes a little
When taking that fuel line off. You should of kept the hose on and put a link in the hose that way it will stop
*kink
At 4.25 u pick of a hose wat hose is this were do's it lead to
Hello someone please help I took that hose off at 4.28 mark but can't figure where does that hose go cause it fell out i know it goes to the carburetor in one side but where is it attached to
Is there an idle screw and air screw? Where are they exactly?
My 87 only had an idle screw. But it was clogged with dirt from a torn boot gone un noticed for years. I replaced it with a cheap carb from eBay. Its an exact clone of the stock mikuni but it has the air screw and runs perfect. Only needed slight adjusting
@@dylanwillyams send us the ebay link please.
@@shawnofthedead1029 www.ebay.com/itm/Carburetor-Carb-For-Suzuki-LT80-LT-80-QUADSPORT-ATV-13200-40B00-13200-40B10/263951236257?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649
@@dylanwillyams thanks buddy.
Hey do you think you could send me a fuel line configuration or explain it to me. my just flooded the case last time ive tried and I just let it set after draining about to try again.
I need help knowing which hose runs where from petcock to carb too please
whats the thing that the float opens and closes?
Isaac Lopez
It's called the needle and seat my brother..
Isaac Lopez needle and seat
use premix and empty to oil injector tank its better to mix than take the chance of running it dry. you can leave it all attached I don't trust mine or any injectors for oil. id rather be safe than sorry I need a new topend.
I have taken out the carb in my lt80 so much that I know the ins and out of it
Does anyone know why my LT80 is flooding so much that fuel is going into my clutch area and out the air filter?
I’ve an lt80 I’ve taken the carb apart so much that I know them inside and out
What is the fuel to oil mixture on these LT80s? I am asking for a friend.
@@shawnofthedead1029 40:1 is the leanest i would recommend.
Just got a lt80 and there is no lines coming from gas tank just 2 empty holes. Can any one tell me how to run the hoses?
Alright, So one should be capped off its a vacume line, The line in the back is the vaccum line the line that is directly under the shutoff lever is the one that should run to the carb
the needle valve assembly
Jst what we wanted ....
My suzuki lt80 go's in high rpms and i cant change it by turning the iddle screw
More than likely your throttle slide is in wrong, it should go all the way down in there, The throttle slide cable has a slot that some people mistake as where the idle mix screw is supposed to be just keep moving it in different positions until it goes all the way down
@@jaydenbutler2116dude this helped a lot 😂 didn’t have it in all the way but I still only have like quarter or half throttle…
Help my lt 80 is smoking to much can some one help me out
Check the reed valves. Mine did too. Easy fix