2021+ | Model S Viento Front Lip Spoiler Real Molded Carbon Fiber

Our Model S Viento Aero Front Lip Spoiler adds a touch of Carbon Fiber to your front end and upgrades your bumper dramatically.
This aggressive sporty front lip spoiler increases downforce to the front end of your Model S. When paired with our full Model S Body Kit which includes our carbon fibre rear diffuser, side skirts, and canards, this dynamic combo generates enhanced downforce, amplifying the stability of your Model S at higher velocities. We also have 3 carbon fiber spoilers for a more aggressive looking rear end, and more added rear downforce.
Construction: Our front lip is not open or exposed on the bottom like many cheap imports, but it is solid top and bottom. Hollow on the inside of course as it weighs less than 4 pounds. This strong reinforced designed front lip adds minimal weight and is made from a beautiful dry-molded 2x2 carbon fiber weave. This dry molding process adds structure and strength to the front lip, which helps with increased downforce and impact. Choice of Matte or Glossy Finish.
Ground Clearance: Our front Lip Spoiler does not lower your Model S's front bumper overall, but it does extend it forward a few inches. This makes your car slightly longer so we recommend using care when parking near parking blocks and going down steep driveways. Always use your air suspension to raise up your car and be sure to select the memory function to always raise it at questionable locations. This stock TESLA feature is perfect when approaching speed bumps or going down sharp driveways because you only have to save the location once. Just set it to HIGH to avoid damaging the front lip. Furthermore, TESLA's ultrasonic parking sensors do not measure distance to low parking blocks, and if you have a newer Model S, true vision is less accurate currently. We HIGHLY recommend installing our Scrape Protectors Skid Plates as they will save your front end and your front lip spoiler. These install directly on to the underside of the front lip. Once installed, If your front end makes contact with a parking block or with concrete the Scrape Protector's urethane surface will block and absorbs the impact so your front lip will be protected from getting scratched and cracked. Here is a LINK to learn more.
In the event of any contact or impact, do inspect the secure fastening of your Front Lip to ensure safe driving. If reattachment is needed, self-tapping screws/rivets can be employed to affix it firmly to the underside of your bumper.
Installation:
This Front Lip Installation entails 3 screws/rivets to puncture below your bumper (A virtually invisible spot to see when standing and viewing the car). There are also other screws/rivets holes designed to puncture the plastic undertray below your front bumper. The rest of the front lip is held on by 3M double-sided tape (this front lip comes pretaped for ease of installation).