All new Pivot Works bearings going into the 2001/2003/2006 Frankinstien RM125. Swingarm, linkage, wheel bearings. When the steering bearing goes I'll be replacing with Pivot Works. Thanks for the great products Purchased at rockymountainatvmc.com
Hi, thanks for posting this video. I forgot to disconnect the suspension linkage and tried to take the swing arm off I realized quickly what was wrong (I'm not a total idiot) but a thick washer (not sure of the part name) fell out it fits into the hole on the swing arm that the pivot bolt goes through but there is only one and I don't see one on the other side so I am not sure where it goes. If you have any idea what it is it would be a great help. Thanks
Does it matter which direction the flat weird looking bearings go in? One side has a sharper edge than the other almost like the steel plates in a clutch pack
Which way do the inner and outer seals usually go? Do the lips face inside or out? I took mine apart last week and didn't write down the way they came out, now I'm not sure.
All new Pivot Works bearings going into the 2001/2003/2006 Frankinstien RM125. Swingarm, linkage, wheel bearings. When the steering bearing goes I'll be replacing with Pivot Works. Thanks for the great products
Purchased at rockymountainatvmc.com
The spring on the seals goes towards the inside of the swingarm.
Hi, thanks for posting this video. I forgot to disconnect the suspension linkage and tried to take the swing arm off I realized quickly what was wrong (I'm not a total idiot) but a thick washer (not sure of the part name) fell out it fits into the hole on the swing arm that the pivot bolt goes through but there is only one and I don't see one on the other side so I am not sure where it goes. If you have any idea what it is it would be a great help. Thanks
Good video. Descriptive. One problem, though. Press the brake without something installed between the pads?! Uhh, that's gonna be a mess!
hell yeah
Does it matter which direction the flat weird looking bearings go in? One side has a sharper edge than the other almost like the steel plates in a clutch pack
Which way do the inner and outer seals usually go? Do the lips face inside or out? I took mine apart last week and didn't write down the way they came out, now I'm not sure.
Great video. K.I.S.S.
Why not install a grease fitting so grease can be put in periodically?
how do you know when the bearing is in all the way? will it come out the other side?
Was thinking the same thing
Check your service manual
how do you know when you need to replace bearings?
Cheers,
Daniel.
It is a CRF250r 2005 if that helps.
Work on a 400ex?