I marked the magnet position on the end of the shaft of the Axis. Broke the magnet fixture and glued It 180° of original position. After that, i calibrated It and It Works. Save me a Lot of time , otherwise It should be sent to service
Calibration does not happen. The right stick is in the middle but appears at the top of the display. It comes in the middle when the left stick is in the middle, but vice versa when it's down. please answer. what should I do?
thank you bro
Mine calibrates but it doesnt keep the calibration,within 2 minutes it gets moving
yes dont do circles just a + sign
don't do circle.. just go left and right then up and down.. I hope work after that.. I faced the same problem
It worked for you?
@@manvsbando yes
@@dndon2007 thanks
I marked the magnet position on the end of the shaft of the Axis. Broke the magnet fixture and glued It 180° of original position. After that, i calibrated It and It Works. Save me a Lot of time , otherwise It should be sent to service
@@recifestargazer2192 in my case it was a broken cable
Calibration does not happen. The right stick is in the middle but appears at the top of the display. It comes in the middle when the left stick is in the middle, but vice versa when it's down. please answer. what should I do?
I think yours is broken, mine immediately respond. I think there is deadzone, very small for the throttle
by the way thanks, I was looking for the calibration menu when I watch your video
Did you ever get this working?
Yes i flipped the magnetic ring inside the gimbal by 180degrees, it had a little bump on one side
@@flugfuchs thanks 😁
@@flugfuchs can you make a video about how to fix it
Hmm I will have to look for this
@@flugfuchs
I have the same problem with the jumper t pro. Do you have a video on how to fix this? Thanks.