Have you tried the new aimrite international roller muzzle that just came out? (I’m pretty sure the aimrite international in Australia and aimrite USA is run by 2 different people?).
Yes, both companies are owned by different people. I’m still waiting to try out the Aimrite International SR muzzle. It’s supposed to fit a 26mm inner diameter barrel.
Have any tips for getting the muzzle track height to line up with the barrel track. I don’t have a router but would sanding the muzzle track down work?
@@unkolearnuhow followed your advice and was successful in sanding it down. For anyone else looking to do this, I would recommend using a longer steel rod (like a pole spear injector rod) instead of a pencil. Also be prepared to put some elbow grease into it because it took me several hours to sand it down to the appropriate height.
I will typically bore out the barrel on the handle end when its needed to meet up with the track offset. For the muzzle end I prefer to sand down the adapter, so it stays centered inside the tube.
Do you have a website or inline store with inventory for sale?? Thanks
Have you tried the new aimrite international roller muzzle that just came out?
(I’m pretty sure the aimrite international in Australia and aimrite USA is run by 2 different people?).
Yes, both companies are owned by different people. I’m still waiting to try out the Aimrite International SR muzzle. It’s supposed to fit a 26mm inner diameter barrel.
Have any tips for getting the muzzle track height to line up with the barrel track. I don’t have a router but would sanding the muzzle track down work?
Yes, you can simply wrap a pencil with 60 grit sandpaper and work to get it even. 🤙🏽
@@unkolearnuhow followed your advice and was successful in sanding it down. For anyone else looking to do this, I would recommend using a longer steel rod (like a pole spear injector rod) instead of a pencil. Also be prepared to put some elbow grease into it because it took me several hours to sand it down to the appropriate height.
@@axelherrera8447 It shouldn’t take more than 10-15 minutes with an aggressive grit.
You reckon sanding the adaptor down is better than boring the barrel out?
I will typically bore out the barrel on the handle end when its needed to meet up with the track offset. For the muzzle end I prefer to sand down the adapter, so it stays centered inside the tube.