Scanning Workflow to Fabricate a Complete Lower Denture

This patient had all his teeth extracted 4 weeks ago and was ready to start the process of fabricating a Complete Lower Denture to bite with his existing Complete Upper Denture. Using the Trios 4 Intra-Oral scanner, has made it easy for me to make a denture that will be extremely accurate fitting in the mouth, made with stronger material and done in less appointments then if this denture was done the conventional way.

[@reaper98765]

That was tight. Good content

[@smilehighclub6176]

Thanks CryptoReaper76.👍🏻 Don’t forget to subscribe for more digital denture content.

[@dent0osh]

can you please post the rest of the procedure, like did you 3d print a cast and arrange the teeth on it or did you immediately print the denture and put the teeth

[@user-gs8ub4nr8u]

Hello ! wish you are fine
Thank you for your videos, find them very intersting
Just one question about scaning the occlusion and the vertical dimension, i didnt understand the technique and tell me plz if there is another techniques for taking the occlusion
Thank you

[@smilehighclub6176]

Hello Dr Sohaib, there are many different ways on recording a bite registration digitally. You may use the denture the patient is wearing, you can use a centric tray or you can use bite rims. I have more videos that outline all of the different ways of doing a bite registration. Please like and subscribe do more videos.👍🏻

[@ddsestephan]

We studied in school that we beed a functional impression , we also need to move soft tissues to avoid future dislodgment and better fit. How can we get this results with the scanner?

[@MissSpaz]

Wait what? Move soft tissues? Nah man. I lost all my teeth at age 22 due to a severe illness that I wasn't expecting to survive from. And they never had to move any soft tissue around...

[@sammycruise6404]

i have a question, in regular alginate impression we record in functional state as well by retracting the cheeks n rotating them even perform tongue movements does the scanner record the mucosa in functional state as well?

[@LabGuyfromFL]

The scanner will only scan mucostatic tissue since no pressure is being applied. However, you can add pressure into your denture design for retention. For example, a common addition is the palatal seal.

[@MissSpaz]

Is it possible for me to get my gums 3D scanned, and to have the 3D models sent to a dental artist to create new implant supported dentures for me? And then have them sent to me????

[@smilehighclub6176]

Hello Miss Spaz, yes it can be done. Not sure what you mean by have them sent to you. You will have to go back to the dental provider to have them inserted.

[@edbroggi]

You mill the partials as well?

[@smilehighclub6176]

Yes, I can oversize mill partial acrylic dentures.