FreeCAD 0.21 Beginners tutorial: practical exercise 122 (PartDesign, Sketcher, SheetMetal)

Hello!
I hope you like this video. In this video you will see how to easily design the model using PartDesign, Sketcher and SheetMetal workbench tools.
Download the drawing exercise here page 33:
ko-fi.com/s/2f...
Support the channel:
ko-fi.com/offs...
Also watch:
• FreeCAD 0.20-0.21 Begi...
• FreeCAD 0.20-0.21 Begi...
• FreeCAD 0.21 Beginners...
#freecad #freecadtutorial

[@sjn8099]

THat was awesame. Thank 🙂you

[@LFANS2001]

Well done, thanks for the time spreading knowledge within FreeCAD community. Regards

[@mm-tw6sz]

very nice introduction to the use of sheet metal for me. Thanks!

[@gweliver]

Thank You for this Tutorial. When I finished this exercise I also converted into a drawing in the Tech Draw Work Bench (WB). While in the Sheet Metal WB I also flattened the 3D view, in which you did not show, but I considered this really important so I included this in my drawing. I saved my Drawing on a A3 sheet in the Tech Draw WB, so I could print everything to scale. This lets us use the drawing as a paper template to cut out the sheet metal with. I glue the paper drawing directly onto the sheet metal and cut out with my saw, plus all the center points for the circles and radius, etc. I use my center punch from the drawing. I do not take time transferring the dimensions from the drawing to the sheet metal, because everything is already on the drawing. I will provide either a pdf or jpg or both, if anybody wants a copy I am glad to help because I learned from providers like You!!! THANKS YOU !!!

[@OffsetCAD]

Thanks.

[@AndersonFilippi]

Hi there! Awsome video. I followed it without any problems. Where did u get this exercise? Can u share with us? Tx

[@TestTest-eb8jr]

Where do I find the drawing to this exercize???

[@gweliver]

I did a screen shot with snippet when he showed the model at the start, I always do this, then save it, right?

[@TestTest-eb8jr]

@@gweliver there must be a better way than that....

[@palvini]

hi i got this error while bending The bend line sketch Sketch003 is not overhanging the face sufficiently at one end or both, extend to get reliable results for the unfold operation whats solution ?

[@OffsetCAD]

Do you still have that problem?

[@palvini]

@@OffsetCAD usually i getting this error but not problem anymore