@@BOJANBAJALICA Check a water leveller inside water tank ( grey rectangular part, that float inside little transparent container). It can stuck on low position - so machine “thinks” that water level is low.
Rinsing ended then after some amount dispensed water from panarello (200ml will be enough), machines got signal from water level sensor ( float-magnet inside water container in down position). So, there is suggestions: or flowmeter didn’t count amount of water passing through system; or float-magnet/water_level sensor problems
You helped me, thanks!
Not at all.
@@OlegPC On my machine write Fell watertank after all procedure always
@@BOJANBAJALICA Maybe, it’s normal. Don’t mind. Just fill water tank with water.
@@OlegPC Maybe i dont have a watertank sesor.. i cant get message "its ready for use"
@@BOJANBAJALICA Check a water leveller inside water tank ( grey rectangular part, that float inside little transparent container). It can stuck on low position - so machine “thinks” that water level is low.
Thank you, so much!
Not at all.
For me, after it descaled, it now has been endlessly saying "rinse machine" and dispensing water from the steam wand, and theres no way to cancel.
Rinsing ended then after some amount dispensed water from panarello (200ml will be enough), machines got signal from water level sensor ( float-magnet inside water container in down position). So, there is suggestions: or flowmeter didn’t count amount of water passing through system; or float-magnet/water_level sensor problems