this is about 5 meters (~16.5 ft) with pipe. this exact unit is rated for 15m (~50ft) without extra filling of refrigeant. with extra it's possible to reach around 20m (~65,5 ft). I doubt that this length is having any impact on the efficiency.
Hei montasjetid vil variere veldig avhengig av tilkomst og lengde mellom inne- og utedel. typisk varer en installasjon fra 3-8 timer. man trenger både elektriker og montør, men noen elektrikere er også varmepumpemontør. sjekk litt rundt og snakk med noen i nærområdet, så kan de komme med forslag / tilbud ;)
Ikke mulig å ettermontere, men mulig å ha to innedeler (M18 heter maskina da). Du vil også få mindre effekt siden du må dele effekten på 2 innedeler. Jeg ville anbefalt å snakket med en leverandør og fått en befaring 😉
Using nitrogen (N2) to 25 BarA, then spraying on either soapy water or leak finder spray. Next I vacuum down as low as possible, (under 200 microns) and put shut the valve to the vacuum pump. If the vacuum has not risen over the 200mic limit after 10-15 mins, I open the valves and let the gas out to the pipes.
@@HowieNOR Thank you for answer. IMHO better use special reductor and pressurise till 40 Bar (R410a and R32 working pressure even higer). About vacuum - it is waste spend of time; dP is too low for small leakage detection; Please, could U inform about brand and model of leak finder spray. Thank you.
Why in 2021 there is nothing for central air conditioners with wired Toshiba RAV SM 806 BTP-E consoles it was necessary to make a remote control, albeit a wired remote control, but to have an IR sensor or make it possible to connect it to the indoor unit board
not quite sure if i understand your comment, but the units for duct connection (BTP-E) can be connected to an wired remote, or an IR remote. you can also get an Modbus interface if you have a home automation system that can communicate over modbus. the newer version of the 800 series would be an Toshiba RAV-GM801ATP-E / RAV-RM801BTP-E (outdoor unit / indor unit)
personally I like the Toshiba D9 best, but check the spec on both machines in your climate, there could be differences and most important find a supplier/installer in your area who is serious about it. cheapest is not always best ;)
@@roccotalarico847 Mainly because that's what i work most with. And in my experience so far, is it less problems with them. no hate over the other brands, they have many good machines as well.
Winter wonderland.
That is quite a long few meters of pipes from the indoor- to the outdoor unit. Does this affect efficiency to any notisable degree?
this is about 5 meters (~16.5 ft) with pipe. this exact unit is rated for 15m (~50ft) without extra filling of refrigeant. with extra it's possible to reach around 20m (~65,5 ft). I doubt that this length is having any impact on the efficiency.
Hvor lang tid bruker man ca på installasjon av brukt varmepumpe fra Panasonic? Trwnger man både elektriker og montør?
Hei
montasjetid vil variere veldig avhengig av tilkomst og lengde mellom inne- og utedel. typisk varer en installasjon fra 3-8 timer.
man trenger både elektriker og montør, men noen elektrikere er også varmepumpemontør.
sjekk litt rundt og snakk med noen i nærområdet, så kan de komme med forslag / tilbud ;)
@@HowieNOR Er det lov å montere og legge opp alt av rør og ledninger og få elektriker/montør til å koble opp? Er nevenyttig til å få dette til selv.
Kan man ha flere innedeler på Daiseikai 9-35? Har ett to etasjer gammelt trekkfult hus🤗
Ikke mulig å ettermontere, men mulig å ha to innedeler (M18 heter maskina da). Du vil også få mindre effekt siden du må dele effekten på 2 innedeler.
Jeg ville anbefalt å snakket med en leverandør og fått en befaring 😉
Takker, ja det skal jeg gjøre🤗
Hvor gjorde du av dreneringen til innedelen? Kan ikke si jeg så noe rør som forlenger dette helt bort til utedelen.
Den ble lagt ut igjennom terminalen/dekslet ved gjennomføringen.
@@HowieNOR Så den drenerer bare ut midt på veggen?
How do you check for leakage? Pressure and dP or Pressure and No bubbles?
Using nitrogen (N2) to 25 BarA, then spraying on either soapy water or leak finder spray. Next I vacuum down as low as possible, (under 200 microns) and put shut the valve to the vacuum pump. If the vacuum has not risen over the 200mic limit after 10-15 mins, I open the valves and let the gas out to the pipes.
@@HowieNOR Thank you for answer. IMHO better use special reductor and pressurise till 40 Bar (R410a and R32 working pressure even higer). About vacuum - it is waste spend of time; dP is too low for small leakage detection;
Please, could U inform about brand and model of leak finder spray. Thank you.
Why in 2021 there is nothing for central air conditioners with wired Toshiba RAV SM 806 BTP-E consoles it was necessary to make a remote control, albeit a wired remote control, but to have an IR sensor or make it possible to connect it to the indoor unit board
not quite sure if i understand your comment, but the units for duct connection (BTP-E) can be connected to an wired remote, or an IR remote.
you can also get an Modbus interface if you have a home automation system that can communicate over modbus.
the newer version of the 800 series would be an Toshiba RAV-GM801ATP-E / RAV-RM801BTP-E (outdoor unit / indor unit)
@@HowieNORhow can i connect it to IR remote ?
@@HowieNOR Is there some kind of module for this, if there is, what is it and how to connect it?
@@HowieNOR You write that : connection (BTP-E) can be connected to IR remote. Okay, can I do it, what do I need for it?
@@HowieNORand what do I need to buy for this so that I can use IR remote
Mitsubishi ln or Toshiba super daisekai 9 ? What Is the best ?
personally I like the Toshiba D9 best,
but check the spec on both machines in your climate, there could be differences
and most important find a supplier/installer in your area who is serious about it. cheapest is not always best ;)
@@HowieNOR thank you for the reply... Why do you prefer Toshiba?
@@roccotalarico847 Mainly because that's what i work most with. And in my experience so far, is it less problems with them.
no hate over the other brands, they have many good machines as well.
Daikin is easy'er to do service on later on (change of data card etc) .
Kjeltring. .. Totalt galt montert
hva mener du er galt? har montert en hel drøss tilsvarende, og har ikke hatt klager 😅