HOW to set parameters for status RGB led in arducopter

how to set parameters for rgb module in arducopter
open Ntf_led_type in parameters list

[@lightlord299]

hey which pad should i use the telemetry connection i am also using gps + compass

[@dronetechnology2772]

Flight controller pls

[@dronetechnology2772]

If speedybee than use vtx wala rx and tx + 5 volt from any pad

[@dronetechnology2772]

T1 and r1

[@dronetechnology2772]

Set baud rates 921600 and protocol mavlink

[@lightlord299]

@@dronetechnology2772 I made a telemetry using HC 05 blutooth module it works and gives 70 to 80m range

[@A_Virtual-tech]

Bro my INAV FPV drone altitude hold working well but position hold not working help me

[@dronetechnology2772]

Place ur gps faraway from ur electronic s

[@A_Virtual-tech]

Hi

[@dronetechnology2772]

Which gps u are using

[@A_Virtual-tech]

@@dronetechnology2772Geprc M10Q GPS

[@A_Virtual-tech]

Geprc m10Q GPS ​@@dronetechnology2772

[@dronetechnology2772]

Ok firmware inav or arducopter

[@dronetechnology2772]

Qno 120 ,180,250