Great video Hamed. I am thinking of getting this same servo to operate a turn table. Do you just use D0.0 , D0.1, D0.2, to supply current to PUL+, DIR+, ENA+ and then run wire from PUL-, DIR - and ENA - to the -24vDC circuit to close the loop?
Nice hobby. We have done these in the college. Plus we had some ready made projects to try out in the lab. Like caraosel sorting. But we used only omron plc's.
how to control steps movements, like.. lets say we have 400 circular points to move pointer one by one and i need to move pointer in following example sequence starting from 0->10->240->45->28-> 56->90->...........and-so-on...... -> 400 . How can we automate this as input all sequences altogether through file or any other way
![Gunna - one of wun [Official Video]](http://i.ytimg.com/vi/w_JtBYqMgk8/mqdefault.jpg)
Great video Hamed. I am thinking of getting this same servo to operate a turn table. Do you just use D0.0 , D0.1, D0.2, to supply current to PUL+, DIR+, ENA+ and then run wire from PUL-, DIR - and ENA - to the -24vDC circuit to close the loop?
Nice hobby. We have done these in the college. Plus we had some ready made projects to try out in the lab. Like caraosel sorting. But we used only omron plc's.
im a big fan keep going!!
could you telk about wiring with servo driver
Hope you are doing well. Havent seen you post in 4 months.
Noce setup..
Hello brother can you share links of your programs ?
can you help me to find right course and country to do masters in electronics
how to control steps movements, like.. lets say we have 400 circular points to move pointer one by one and i need to move pointer in following example sequence starting from 0->10->240->45->28-> 56->90->...........and-so-on...... -> 400 . How can we automate this as input all sequences altogether through file or any other way
I still don't understand why need by a new plc. Its easy just by an external relay mechanical or solid State which can handle big power.