Bit late to the party I guess, and perhaps I was too stupid to figure it out, but: While the top radiator mount will accept my 240mm AiO (and I've no doubt if I left out the ODD cage a 360 would fit), there was no way for me to get the radiator and its fans up there. The top heatspreader on my MSI Z690 Tomahawk mobo didn't leave enough clearance for the rad and fans to fit up there. And the most frustrating part was that it was just a tiny bit of additional clearance I would've needed... like 5mm or so. But the heatspreader was definitely both too high and too thick to allow the rad/fans to fit up there. The case would need to be a bit wider or taller or the mainboard-tray would need to be sitting a bit closer to the non-glass sidepanel. My original plan was to put the radiator up top running as an exhaust, a 120mm at the rear as in intake to feed the rad and two 140mm at the front, blowing in. As it is, I reluctantly had to mount my AiO radiator behind the front panel, put the two 140mm into the top as exhausts and the 120mm as a rear exhaust. So now I'm blowing hot air into my case and the fans are a bit chocked by the not-very-open front panel. I just ran a few tests with Passmark's CPU tests and prime95 both with the panel on and off and I got up to 5°C difference between runs (panel off ran cooler of course).
When you have more fans than than you can plug in inside your mainboard, you can use that. Normally you don' need them, so you put them aside. But if you use it, you will have to power it up with a SATA-Cabel with the cabel you can see at 5:50 . Sorry about my English spelling (I'm from Germany)
@@felixgeisler3637 ich hab ein Asrock Mainboard und da hab ich das problem das ich auf beiden Seiteb Pins aber kein Socket habe. Somit funken die Lüfter net.
zrovna nedávno mě tato novinka zaujala ..dík za povedené video když už je to recenze tak by bylo super na konci shrnout hlavní plusy mínusy (osobně bych ocenil hlavně ukázku tuhosti očesané skříně a změření/uvedení tloušťky plechů)
You know what would have helped? Is how you installed the freekin drives. I just bought the lower end model (Base 600) and so far am unimpressed! Zero instructions of any use and I'm hoping to see how to install my SSD and of course you don't even show it installed, let alone how you installed it. There were several steps missed. Thanks....
Doing a build atm with twin samsung 980 pro 1TB M.2 SSD gonna rip out all the drive bays and put in a 360mm Be quiet water cooler. It should look sik, I am exite.
Hey mate - if I dont use the 140mm included.. and i want to add more 120mm fans.. how many total 120mm fans can i use? is it.. 1 at the back 3 up top then 3 up front? thanks!
Little late here, but you can fit two SSD's behind motherboard and three HDD's in the bays which the OP removed. If you have extra long GPU, you can remove top bay and still have room for two HDD's.
@@MartinsTips thanks one last question so I got that case and I think I have the wrong power supply so I’m wondering what power supply do you have it would help me out a lot thanks
Díky neuvědomil jsem si ze to je jiny typ. Muzu se zeptat, ja skladám poprve svuj pc ale nevim kolika watovy zdroj dát ke komponentum vim ze od firmy be quiet 😀 koponenty: i7 7700k asus gtx 1080. stači 700w pure power 10 cm? Díky za odpověď.
Артем Шемигон это би квайт дружище, это фирма зарекомендовавшая себя исключительно с лучшей стороны. Это красивый, и хорошо продуваемый холодильник, никаких нареканий. Блок питания тоже от этой фирмы стоит, я доволен, советую вобщем; если с бюджетом напряг только тогда поккпка становится нерациональной, главное чтоб не в ущерб комплектующим. Как вариант обрати внимание на залман тройку, не плохой и дешевле.
Смотри, впереди две вертушки по 140мм стоят, если мало можно третью установить; сзади одна на 140 стоит, снизу тоже установлена, вверху ну тут хз, теоритически можно вообще один на 180мм поставить, да и массивная вода без замечаний встанет; на моей же системе два по 140 вверху установлены. Все на резиновых подкладках держится, крутится, и не шумит.
Bit late to the party I guess, and perhaps I was too stupid to figure it out, but:
While the top radiator mount will accept my 240mm AiO (and I've no doubt if I left out the ODD cage a 360 would fit), there was no way for me to get the radiator and its fans up there. The top heatspreader on my MSI Z690 Tomahawk mobo didn't leave enough clearance for the rad and fans to fit up there. And the most frustrating part was that it was just a tiny bit of additional clearance I would've needed... like 5mm or so. But the heatspreader was definitely both too high and too thick to allow the rad/fans to fit up there. The case would need to be a bit wider or taller or the mainboard-tray would need to be sitting a bit closer to the non-glass sidepanel.
My original plan was to put the radiator up top running as an exhaust, a 120mm at the rear as in intake to feed the rad and two 140mm at the front, blowing in. As it is, I reluctantly had to mount my AiO radiator behind the front panel, put the two 140mm into the top as exhausts and the 120mm as a rear exhaust. So now I'm blowing hot air into my case and the fans are a bit chocked by the not-very-open front panel. I just ran a few tests with Passmark's CPU tests and prime95 both with the panel on and off and I got up to 5°C difference between runs (panel off ran cooler of course).
What sort of cable is it in 6:01 and where to put it?
If you find an answer please tell me !
When you have more fans than than you can plug in inside your mainboard, you can use that. Normally you don' need them, so you put them aside. But if you use it, you will have to power it up with a SATA-Cabel with the cabel you can see at 5:50 .
Sorry about my English spelling (I'm from Germany)
@@felixgeisler3637 ich hab ein Asrock Mainboard und da hab ich das problem das ich auf beiden Seiteb Pins aber kein Socket habe. Somit funken die Lüfter net.
Does it have a reset button?
zrovna nedávno mě tato novinka zaujala ..dík za povedené video
když už je to recenze tak by bylo super na konci shrnout hlavní plusy mínusy (osobně bych ocenil hlavně ukázku tuhosti očesané skříně a změření/uvedení tloušťky plechů)
Diky za rady! Bude aj písaná recenzia na www.pcnadsenci.eu :)
You know what would have helped? Is how you installed the freekin drives. I just bought the lower end model (Base 600) and so far am unimpressed! Zero instructions of any use and I'm hoping to see how to install my SSD and of course you don't even show it installed, let alone how you installed it. There were several steps missed.
Thanks....
Thanks. Helped me with packing it back in
Doing a build atm with twin samsung 980 pro 1TB M.2 SSD gonna rip out all the drive bays and put in a 360mm Be quiet water cooler. It should look sik, I am exite.
Amazing.
ty for showing possibility to install water cooling in this case.
Like +1
Thanks! :)
I have a question are the standoffs already mounted ?
Yes :)
Hey mate - if I dont use the 140mm included.. and i want to add more 120mm fans.. how many total 120mm fans can i use? is it..
1 at the back
3 up top
then 3 up front?
thanks!
HDD and SSD where ?
Maybe he has M.2 SSD?
Little late here, but you can fit two SSD's behind motherboard and three HDD's in the bays which the OP removed. If you have extra long GPU, you can remove top bay and still have room for two HDD's.
6:00 this cable what is it, where i connect it im lost :/
thats the same reason I'm here did you ever figure it out?
@@Johnprater99 yes is for connect another case fan
would a KFA2 rtx 2070 super fit in that case? its 295*143*52mm
the be Quiet! Dark Rock Pro 4 cpu cooler can fit in this case?
yep!
HI !! Is there someone could tell me how connect Fans speed controller 2 cables ( one sata and one 2 pins )
I need help to bruh
Everybody seems to have this problem. What do we do with this 2-pin fan connector?
Very late but what processor is that
I don't remember exactly, but most probably it was i7- 6950x or i7-6900k :)
@@MartinsTips thanks one last question so I got that case and I think I have the wrong power supply so I’m wondering what power supply do you have it would help me out a lot thanks
@@carterm180 You shoud buy power supply which is good for your HW, I don' know which HW you have, I use more power supply units ...
@@MartinsTips I’m sorry I’m kinda new to pcs I don’t know what a hw is
@@carterm180 hw = hardware (components)
What screw do you use to attach the motherboard to the standoffs?
Such srews usually included with motherboard.
is the a place for a hdd?
There are but he took them off.
kde se da sehnat ta verze s vekym oknem? na alze je s malym.
To na alze nie je PURE BASE, ale Silent BASE
www.mall.sk/skrinky/be-quiet-pure-base-600-okno-cierna-bgw21
Díky neuvědomil jsem si ze to je jiny typ. Muzu se zeptat, ja skladám poprve svuj pc ale nevim kolika watovy zdroj dát ke komponentum vim ze od firmy be quiet 😀 koponenty: i7 7700k asus gtx 1080. stači 700w pure power 10 cm? Díky za odpověď.
www.bequiet.com/en/psucalculator Tuto je kalkulačka výkonu, priamo na ich stránke, ale mal by byť ok :)
Cool bright wall.
Sharp looking case!
Thank you!!!!!! Very helpful :)
Song 0:12 ??
i really care about the manual. lol
What cooler for CPU is it?
Be quiet! Dark Rock 3
Martin's PC Tips Beautiful assembly, Which power supply?
Thank you! Corsair RM850
Is there enough room to fit a PSU shroud between the motherboard and psu?
A thin shroud.
Мой корпус
Андрей Милетенко Железо в нем сильно греется?Скажи пожалуйста,сам думаю такой купить.
Артем Шемигон это би квайт дружище, это фирма зарекомендовавшая себя исключительно с лучшей стороны. Это красивый, и хорошо продуваемый холодильник, никаких нареканий. Блок питания тоже от этой фирмы стоит, я доволен, советую вобщем; если с бюджетом напряг только тогда поккпка становится нерациональной, главное чтоб не в ущерб комплектующим. Как вариант обрати внимание на залман тройку, не плохой и дешевле.
Спасибо огромное
Где ты ставил вентиляторы?(места их размещения)
Смотри, впереди две вертушки по 140мм стоят, если мало можно третью установить; сзади одна на 140 стоит, снизу тоже установлена, вверху ну тут хз, теоритически можно вообще один на 180мм поставить, да и массивная вода без замечаний встанет; на моей же системе два по 140 вверху установлены. Все на резиновых подкладках держится, крутится, и не шумит.