In auto tuning mode driver aquare required parameters by it self that parameters can be rotar resistance, reactance, full load current and no load current etc for different purpose like built in protection setting that provides by driver, energy savings, acc/deacceleration time management and many more..For auto tuning you have to tune special parameter that can find tipically in driver datasheet...
@@automationhouse8613 sir i have one doubt . iam using delta plc dvp-sa2 series and dop-107cv hmi through rs-485 communication... . how to set rs-485 communication(baud rate , stop bit , parity , timeout) in plc side.
Наука
Well explained. Thank you for sharing Ur great knowledge . If you giving English subtitles it more helpful for us. Thank you lot
well shown thanks , if u speak English or subtitles would be even better to reach more non Indian speaker. Thanks for sharing 💕
Where u use xp?
hi sir Schneider plc me proximity sensor se moter RPM speed measure kaise karte hai ek video banav sir.
How can program machine running time in LS PLC? if power failure time is remain.
Is it c235 denote xo channel of plc?
Yes
can you explain to me, is it possible to make an electric meter on delta hmi for a day ???
Off course we can design 😊
@@automationhouse8613 do you have a video about this ?
@@NoName-ut9wd sorry dear not have right now but will upload in future..
@@automationhouse8613 understandably, now I have like this problem, thanks for the answer, good luck sir !!!
how to do "auto - tuning" in vfd and servo.
what is the usage and procedure...
In auto tuning mode driver aquare required parameters by it self that parameters can be rotar resistance, reactance, full load current and no load current etc for different purpose like built in protection setting that provides by driver, energy savings, acc/deacceleration time management and many more..For auto tuning you have to tune special parameter that can find tipically in driver datasheet...
@@automationhouse8613 THANKS FOR YOUR VALUABLE INFORMATION..
Welcome
@@automationhouse8613 sir i have one doubt . iam using delta plc dvp-sa2 series and dop-107cv hmi through rs-485 communication... . how to set rs-485 communication(baud rate , stop bit , parity , timeout) in plc side.
Not required any special setting you just chose setting com port, rs485 and baud rate etc when you creating HMI screen
well shown thanks , if u speak English or subtitles would be even better to reach more non Indian speaker. Thanks for sharing 💕