Thank you so much for the reply!!! I have to generate spiral cooling channel for the torch at its outer periphery . But, I don't know know how to do it. Could you please help me out? Please, provide your email so that I can send you details.
When you get the fill results,the "total part weight at the end of filling" includes the weight of the runner wizard or it is only the weight of the piece? thanks!
While I was doing the analysis I give the input water temp 25C and 40C but results come same values for both.Can you tell me how to rectify this problem..?
hello, can i ask why my analysis havent started even i clicked the "start analysis" button
Thanks for big lesson change Cs area means sink mark
Can i use MoldFlow to simulate the rubber injection or it just for plastic injection
Hiiii, can you tell me how to import cooling channel ? As it say import channel but when i import iges it doesn't show anything.
Can we generate spiral cooling channel for this product?
Thank you so much for the reply!!!
I have to generate spiral cooling channel for the torch at its outer periphery .
But, I don't know know how to do it.
Could you please help me out?
Please, provide your email so that I can send you details.
When you get the fill results,the "total part weight at the end of filling" includes the weight of the runner wizard or it is only the weight of the piece? thanks!
Check with log ...You will get both part + runner as well as part weight after packing
WWwwwwwwwWwwwwww1
I Have a problem with simulation shell you help me?
+Shaik Moulali yes tell me
While I was doing the analysis I give the input water temp 25C and 40C but results come same values for both.Can you tell me how to rectify this problem..?
+Shaik Moulali problem is not clear to me ...