I'm at work doing rear drums right now. I had to look on youtube to figure out how to use this again. It's been probably couple years since i've cut drums lol. Thanks again!
Nice video it's been 30 years sense I used one of these Ammcos .Took a automotive class in 10th grade of high school I remember being fascinated with the machine.So I picked one up for my personal garage.Great overview .Thanks
Great video!!! A have a lab tomorrow where I have to do this. I have already done the on car lathe which was extremely easy, I have also done it on this same mechine but resurfacing a rotor.
I'm at work doing rear drums right now. I had to look on youtube to figure out how to use this again. It's been probably couple years since i've cut drums lol. Thanks again!
Thank you. You are a very good instructor. well done!
Nice video it's been 30 years sense I used one of these Ammcos .Took a automotive class in 10th grade of high school I remember being fascinated with the machine.So I picked one up for my personal garage.Great overview .Thanks
Great video!!! A have a lab tomorrow where I have to do this. I have already done the on car lathe which was extremely easy, I have also done it on this same mechine but resurfacing a rotor.
+Mario Tejada. Thanks Mario, I'm glad I could help.
Great Video, Thanks for sharing your knowledge.
I wish my teacher was as thorough as you
If the drum measured 188mm and the spec is 227mm then the drum seems well under spec, ok to turn.
What type of cutting tips do you use and how many drums can they cut before needing to be replaced?
What a workshop! Fine!
Have you ever seen the small drum tip for doing small brake drums
What do you think about the quick change chuck
Whare can i get this done
nice video good iam asif from mumbai india i want thish machene how much
I enjoyed your video but never thought you were in Kuwait, maybe the moon but im not sure
Why use belt on drum
do you still teath class let me know thank
Bery intrusted thanks.
lot of stuff to go through to use a brake lathe I do them on my engine lathe with a shaft and centering cone and that's it..
Posi como dijo mila
Hi..
Sir where is your agency in kuwait.
I need your address.
Sorry, I'm located in the US. I'll be posting lots of new video's this fall and winter so stop back and thanks for watching.
+Ragib Saba Sorry Ragib, I'm not in Kuwait. Let me know which video helped and if you would like to see others in the future. Glad to help.
If you can the quick chuck makes thing easier when mounting a rotor or drum have you ever see the small drum tip for small brake drums
Great job sir
Where can i get like that machine.
Thanks
Fathi Eljali hi, I can get you one of these lathes. Shipping to you may be expensive though. Let me know
Live in nj
???