Porsche Cayenne 958 Front and Rear Brake Replacement

In this episode of TheFadShow I work on replacing the front and rear brakes on our Porsche Cayenne 958.
Music:
------------------------------
Surfers paradise by Scandinavianz / scandinavianz
Creative Commons - Attribution 3.0 Unported - CC BY 3.0
Free Download / Stream: bit.ly/3n8u92o
Music promoted by Audio Library • Surfers paradise - Sca...
------------------------------

[@StefanHaxxell-pi6zn]

Thanks a lot for this Tutorial

[@galeogaliley5059]

the caliper bolt size would have been nice to mention

[@effa114]

Thanks for this. Recommendations for quality anti-squeal paste and cleaning product for the caliper?

[@billrector]

What is the blue that you are spraying on the back of the pads?

[@mikescayenne]

Did you get the brake dust shield from the dealer?

[@Sencheezy]

Thanks

[@thefadshow]

No problem

[@emilhasanov4342]

Hi . how many brake pad sensor were installed on 2014 Porsche Cayenne ? on each brake pads ?

[@thefadshow]

I think they are just on the driver side.

[@emilhasanov4342]

@@thefadshow Thanks a lot. but i change my brake pads in garage, they sold me 4 pcs brake worn sensor . Previosly i had BMW x 5 , there are 2 pcs sensor one front another rear

[@craigerickson1910]

My 2014 Cayenne GTS has one wear sensor on each inner pad so total of four.

[@thesoundofthesuburbs]

14mm where did you buy?

[@Ficon]

You don't need to get the coating off the rotors, just read the instructions in the box. It burns off after a few brake applications.

[@charlesrosenbloom4140]

some rotors have cutting oil on them still. you need to get that off or it will soak into the pads.

[@Ficon]

@@charlesrosenbloom4140 Cutting oil on coated rotors? I would imagine they are coated after they are finished. Zimmerman specifically says to just drive.

[@gregjwitherspoon]

Any updates on the Cayenne? Would you still recommend it?

[@thefadshow]

I’ll make an update soon!

[@thesoundofthesuburbs]

Do you need a scanner for the rear brakes?

[@thefadshow]

I didn’t use one just make sure brake is off and not dragging. Can use dial adjusted to take tension off it.

[@paulanthony6243]

Was it hard to get the rotors off?

[@thefadshow]

No not any harder than any car that’s had rotors on there for a while.