Laser Air Assist and Riser Base Setup for xTool M1

Поделиться
HTML-код
  • Опубликовано: 28 ноя 2024

Комментарии • 8

  • @nvargas48
    @nvargas48 9 месяцев назад +2

    Thank you, that was a great tutorial, the best I’ve seen!!

    • @Vortimaxx
      @Vortimaxx  9 месяцев назад +1

      You're very welcome!

  • @jojococodesigns
    @jojococodesigns 4 месяца назад +1

    Thank you so much. I watched many other tutorials and my laser cutter was bumping into the LHS at end of a project. I watched your video and finally found out about the marks on the tubing, straightening out the tubing, what the other two grooves were for and the rubber washer. I redid the tubing properly and it now works perfectly. Others just leave these bits out and it caused me a lot of stress thinking my machine was broken - along with the worry about what to do about that as I have just bought it 2nd hand, along with a lot of lost hours. A massive thank you for a professional and thorough lesson.

    • @Vortimaxx
      @Vortimaxx  3 месяца назад +1

      You are very welcome. Yes, the washer is missed on other videos because it's not in the instructions. Glad to hear that I was able to help :)

  • @pinkyscraftplace
    @pinkyscraftplace 5 месяцев назад +1

    I've watched many videos on installing the air assist and some were helpful and got me to a certain point and then I said I'd try again later. Today was my later and your instructions were most helpful, so thank you for helping me to get it installed.

    • @Vortimaxx
      @Vortimaxx  5 месяцев назад +1

      You are very welcome 😊

  • @Seamstressy
    @Seamstressy 21 день назад +1

    Brilliant, thanks for the walkthrough! I look forward to trying my new set up now I've got it all installed :)

  • @janj2790
    @janj2790 6 месяцев назад +1

    Thank you for this video. I love your cat , we also have a black cat.