Leave it to Honda to make it as difficult as possible to work on. I just swapped an alternator. Did they have to run the AC line directly in front of the 2 bottom bolts on the alt? 20 minutes of grief just to get those 2 bolts out.
Gasket maker ? You don’t need gasket maker if it has a rubber gasket. As a Toyota Technician for 10 years I have learned putting gasket maker where is not needed will cause uneven wear and will leak overtime. The rubber gasket purpose is to seat the water pump correctly and prevent it from leaking. Take my advice !
√ Watch the Video
√ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money
Esos 3 tornillos se sacan mejor con un dado 10mm largo y los otros 3 se sacan facilito por arriba sin sacar esa polea!👍👍👍
If you have a gasket on there, you don't need rtv sealant....
Dang I wouldn't want to be an automechanic.you gotta have patience which I'm working on but shoutout to this mechanic you know what you doing.
Leave it to Honda to make it as difficult as possible to work on. I just swapped an alternator. Did they have to run the AC line directly in front of the 2 bottom bolts on the alt? 20 minutes of grief just to get those 2 bolts out.
Wow.....why the hell are you using RTV on the water pump? Its a gasket seal. You just made Honda mechanics cry.
It helps seal better and keeps the gasket from going bad again it doesn't hurt but could help
I watched another video where you go in from the top. Which is easier?
Gasket maker ? You don’t need gasket maker if it has a rubber gasket. As a Toyota Technician for 10 years I have learned putting gasket maker where is not needed will cause uneven wear and will leak overtime. The rubber gasket purpose is to seat the water pump correctly and prevent it from leaking. Take my advice !
He used more gasket maker than I've seen in other videos. Did he use too much, or did the other videos out there use too little?
We need this video for 2002 - 2006 HONDA C-RV Please
Same situation.
He’s going the work under the car or by the passenger side tires
The other guy says you need to remove the engine mount to change the water pump. Is that true?
!!! After torqueing the crank bolt to 36ft/lbs, you are supposed to tighten it an additional 90 degrees!!!
Somehow the power steering pump magically disappeared before you got the belt off 🤔
No wonder labor rates are so high
Look like he didn’t removed