Excellent video. Your “walk through” of the schematic was very helpful, don’t worry about the length of your videos, your explanation of how that meter works is better than 98% of the other electronic videos out there…
Thank you for sharing. There is a red wire routed between two e-caps, in the middle of the board. The builder used the caps to turn the wire from vertical to horizontal. I would think that the extremely close proximity to the caps might lead to the introduction of noise. You might want to move it. I also think this routing indicates that the unit was kit built. Multiturn calibration pots might be a nice upgrade.
Excellent video. Your “walk through” of the schematic was very helpful, don’t worry about the length of your videos, your explanation of how that meter works is better than 98% of the other electronic videos out there…
Thank you for sharing. There is a red wire routed between two e-caps, in the middle of the board. The builder used the caps to turn the wire from vertical to horizontal. I would think that the extremely close proximity to the caps might lead to the introduction of noise. You might want to move it. I also think this routing indicates that the unit was kit built. Multiturn calibration pots might be a nice upgrade.