Should of done this when I did my cams... I saw a post on HDForums that someone successfully insatlled em without taking the rocker support off. He just unbolted 1 corner at a time and installed the Rocker Locker, then did the other side.. Thoughts?
The noise is from the rocker shafts moving and "clicking" against the bolts that hold the shafts in place. The shafts have a notch machined in them and the bolts go through the notch. The rocker lockers basically fill the gap between the shafts and the bolts
Nope. They have a different mounting style where the rocker arm isn’t held in place by the bolt. They do sell shim kits though so you can set the proper end play for the rocker
The best video on how to install Rocker Lockers.
I think I'm ready to do mine now. Thank you.
Sounds tight i like it, gives me confidence to do it my shelf. Thanks Again
Good content bro!!
Thank you!
I wished you lived in the piedmont area of North Carolina. I’d have you do my work … HD services are a joke anymore. Good videos
I have those on all 3 of my twinkies. 😊
Should of done this when I did my cams... I saw a post on HDForums that someone successfully insatlled em without taking the rocker support off. He just unbolted 1 corner at a time and installed the Rocker Locker, then did the other side.. Thoughts?
Sheeesh that’s not a bad idea!
Will shimming the rockers work just as good?
The noise is from the rocker shafts moving and "clicking" against the bolts that hold the shafts in place. The shafts have a notch machined in them and the bolts go through the notch. The rocker lockers basically fill the gap between the shafts and the bolts
Not quite. Shimming in important for the lateral movement, but it will still allow the shaft to move in there a bit
They don't male these for m8s do they? All I seem to find for is TC
Nope. They have a different mounting style where the rocker arm isn’t held in place by the bolt. They do sell shim kits though so you can set the proper end play for the rocker
@GilstrapGarage cool I appreciate ya