Troubleshooting a G3 MSP Frac Auto Lube System

Go over faults and troubleshooting Graco's G3 and MSP frac pump lubrication system. Graco automatic lubrication systems deliver benefit-driven solutions that save you time and money. Perfect for challenging, hazardous and harsh operating conditions of well services. Whether you need electric, hydraulic, or pneumatic powered solutions, we’ve got you covered with multiple levels of control and monitoring.
G3™ Pump and Control
An advanced pump design offers multiple levels of control and monitoring. Use feedback from MSP blocks and from your equipment to tailor and monitor the lubrication supply to critical components. Pumps are IP69K rated so no enclosure is necessary. Refilling is clean and easy with the quick connect stud.
MSP Series Progressive Lubrication Blocks
Offers time-tested, field proven dependability in the harshest environments. Flow can be monitored using a proximity switch and performance indicators so problems can be pinpointed.
Learn more about Graco automatic lubrication systems: www.graco.com/us/en/vehicle-s...

[@eddieyepes5853]

Hello, I have a graco pump installed, it is a G3 Max, it is working and we installed a beacon as an external visual alarm and it was working normally; but in the moments of the electrical cuts the pump restarts and the beacon stayed on for a few seconds and then went off.
but now it stays on all the time without having any kind of failure?
there is no failure in the control of the pump by level, nor by cycles the pump continues its normal operation but the beacon remains on?
Is there any solution?

[@GracoLubricationEquipment]

Hello Eddie, it would be best to call our technical support team to better understand your specific situation. Please call 1-844-241-9503, Monday-Friday, 7:30 a.m.-5:00 p.m. central time. Thank you.

[@camiloampuero1751]

donde puedo tener el vidoe en español porfavor

[@jedmix9337]

I have a graco pump on my loader someone had over filled it so I could not see in it . To tell if it was low . There is a control inside the cab that a alarm started going off on it. I put grease in it I dont know how full it is but I put quit a bit of grease in it. But the alarm is still going off . How do reset it so the alarm is no longer on. Also is there a way I can take the reservoir off to clean it out that way I can see how full it is

[@GracoLubricationEquipment]

Hello,
The left-most button on the controller is the cancel button. You can hold that down to clear the fault and stop the alarm. See the GLC 2200 Controller manual for more info. www.graco.com/content/dam/graco/tech_documents/manuals/3A2/3A2960/3A2960EN-F.pdf
Removing and reinstalling the reservoir is very tricky, so we do not recommend doing that. The grease should fall down on its own over time, and the wiper arm will wipe the sides of the reservoir clean.

[@vicentegomez1892]

quizá buscando un botón que dice,riezetear presionarlo unos instantes se cancele la alarma