Are these the newest displays for the bafang models for all electric bikes ( including the scootstar rockstar and popstar electric bikes ). Also, can you swap your existing display for a new display.
Small question for you. I noticed the level of assistance is changing by itself. I set it to 3, and it will sometimes go up to 5 or down to 1. Is that normal?
It is interesting how every demonstration is inside or in the shade with these full color displays. These are impossible to see in direct sunlight (where we normally ride ebikes) lol I have set the brightness on 5 out of 5 bars. Cannot see any information in the sun. What am i doing wrong..? Please do a review in the direct sun to show us how we can adjust these so we can use them in the sun.
How do you let throttle overide PAS and the speed limiter on the throttle --ie How to make the throttle function like that of a regular moped or motor cycle ?
Mopeds and bicycles are different. You can't go top speed with just the throttle unless you are in the highest gear with the bike. First and foremost this functions as a bike so you'll have to start in a low gear, get moving to shift into the highest gear (9 on our bikes) then as your throttling it will get to top speed.
Unable to highlight the tire size or speed limit? Speed Limit is set for 19.8 MPH, and since I can’t highlight that line, I can’t change it. How do I change the speed limit?
Hi I recently installed this display on my bike, it was to replaced a juiced ebike display. I had to splice on a different connector to attach this display, but everything works. Lights, torque sensing, odometer, etc. However it shows the default 5 pas levels, but my bike only uses 4. I do not see the max pas setting on the display. Could this be the cause of the controller? Any advice is appreciated
My the same odometer is stuck on a password that I reset and I can't it will not accept it what do I do to get my odometer back on or to reset the password
Anybody have software that programs this display? The software that most people use doesn't seem to support the display that has sport/eco modes but instead 5/9 assist levels which doesn't really help much. Other question is about the button that looks like a headlight. Is that for an external relay that can activate lights you can add to the bike to run off the battery? That button wasn't covered here.
We recommend the egg rider display. It connects Bluetooth with a smartphone and you can program the motor exactly like the bafang software. Yes that is for lights. The ultra has a front and rear light connector coming out of the motor.
@@bakcouè compatibile con bafang m500???? Posso sbloccare la velocità di 25 a 50?la bici è fantic issimo.... Si può collegare anche un acceleratore?????
These are beautiful displays, they have all the information you need... PROBLEM IS, you can't see them in direct sunlight. Isn't that where we need to see the display.. My opinion is that they are useless during daylight hours. Sorry, i wouldn't waste the money until they get a Sunlight Readable screen. And Bafang isn't going to do that anytime soon. Bafang doesn't realize that many ebike owners have the extra money for a readable display. (one you can see in the sunlight). Bafang's loss
I'm about to swap my 830S for an 860C, I hope it's visible in sunlight. Another issue I've noticed is some Polaroid Sunglasses are polarized the wrong way and blackout some screens!
Hey I have same display with a 1000 watt midrive dcp18 but does have the green mode eco symbol so I can change to sport how do get this on my screen I push +button but does nothing
That’s correct. The percentage or overall voltage is shown in the upper right hand corner. I can be wrong - I thought while you show the Battery Information/ Index menu you commented „ ... gives us all the information while your are riding“. Unfortunately this menu has no information if a non-Bafang battery is used.
Folks battery information does not display unless you have a complimentary Bafang battery. Otherwise as shown 2:32, there is NO battery information displayed.... ever.
It's not only bafang batteries, the bike needs to be wired correctly to the controller. The discharge connection on the battery also needs to wired to allow communication with the bike, then you will have all battery information on the display. Our 2020 models will all have full battery information available in the display.
ask the big QUESTION.. "Why are these reviews always done inside or in the shade..?" answer: you can't read/see them outside. Bafang doesn't see the problem in a display you can't see.
Thanks for your input, but these displays work great in the sun... we do the demo indoors for convenience. We have other videos of the display outside.
Not sure if there is a general password. It should be unlocked if it is stock. You could possibly order a new display and then change the speed to 40mph
Are all the bafang display units interchangeable/plug and play? I have the DPC 11 and it won’t let me change my speed. Hoping that I can just by a new display and sort it out...
I love this bike! I use it to bike to work everyday in Boulder,C.O.
That's awesome! Are you apart of our Facebook ebike group?
Are these the newest displays for the bafang models for all electric bikes ( including the scootstar rockstar and popstar electric bikes ). Also, can you swap your existing display for a new display.
Small question for you. I noticed the level of assistance is changing by itself. I set it to 3, and it will sometimes go up to 5 or down to 1. Is that normal?
Which display is this one? Mine is like that but don't have the eco or sport mode.
I dont eather
It is interesting how every demonstration is inside or in the shade with these full color displays.
These are impossible to see in direct sunlight (where we normally ride ebikes) lol
I have set the brightness on 5 out of 5 bars. Cannot see any information in the sun.
What am i doing wrong..? Please do a review in the direct sun to show us how we can adjust these so we can use them in the sun.
How do you let throttle overide PAS and the speed limiter on the throttle --ie How to make the throttle function like that of a regular moped or motor cycle ?
Mopeds and bicycles are different. You can't go top speed with just the throttle unless you are in the highest gear with the bike. First and foremost this functions as a bike so you'll have to start in a low gear, get moving to shift into the highest gear (9 on our bikes) then as your throttling it will get to top speed.
Unable to highlight the tire size or speed limit? Speed Limit is set for 19.8 MPH, and since I can’t highlight that line, I can’t change it. How do I change the speed limit?
When you scroll down to it hit the I button and it should let you adjust it. maybe not it is not our bike.
very helpful, thank you
Hi I recently installed this display on my bike, it was to replaced a juiced ebike display. I had to splice on a different connector to attach this display, but everything works. Lights, torque sensing, odometer, etc. However it shows the default 5 pas levels, but my bike only uses 4. I do not see the max pas setting on the display. Could this be the cause of the controller? Any advice is appreciated
isn't the juiced bike a rear wheel motor? I also have rear wheel motor on my ejoe koda but didn't think it would work. any luck on the pas?
Will it work on a Rize ebike?
Hello i wash my bafang electrique bike and it goes off it is only on when it is connected to a charger and get off when disconnected can someone help?
That sounds like a less than ideal day. Sorry to hear. Is it one of our Bakcou eBikes? We are most knowledgeable with our own motors.
Can the ave speed and max speed & ride time be reset
Can i lock the speed limit?
can be installed in an Original SONDORS 3v 350w
I dont think so. Sorry
My the same odometer is stuck on a password that I reset and I can't it will not accept it what do I do to get my odometer back on or to reset the password
Anybody have software that programs this display? The software that most people use doesn't seem to support the display that has sport/eco modes but instead 5/9 assist levels which doesn't really help much. Other question is about the button that looks like a headlight. Is that for an external relay that can activate lights you can add to the bike to run off the battery? That button wasn't covered here.
We recommend the egg rider display. It connects Bluetooth with a smartphone and you can program the motor exactly like the bafang software. Yes that is for lights. The ultra has a front and rear light connector coming out of the motor.
@@bakcouè compatibile con bafang m500???? Posso sbloccare la velocità di 25 a 50?la bici è fantic issimo....
Si può collegare anche un acceleratore?????
@@sandroolivieri5310 reach out to our customer service team to help answer those questions! You could email info@bakcou.com
@@bakcou no gratis!!!😭
These are beautiful displays, they have all the information you need... PROBLEM IS, you can't see them in direct sunlight. Isn't that where we need to see the display.. My opinion is that they are useless during daylight hours. Sorry, i wouldn't waste the money until they get a Sunlight Readable screen. And Bafang isn't going to do that anytime soon. Bafang doesn't realize that many ebike owners have the extra money for a readable display. (one you can see in the sunlight). Bafang's loss
I'm about to swap my 830S for an 860C, I hope it's visible in sunlight.
Another issue I've noticed is some Polaroid Sunglasses are polarized the wrong way and blackout some screens!
We have no problem reading our display in full sun. We will do a video.
Just bought a hand built bike and they didn't even show me how to take the battery off ! Thanx mate ! at $ 5999.00 its a bit rough !
Send us an email with some information about your bike and a few pictures, we can help find you some information... info@backcountryebikes.com
Oh man!!!!
Hey I have same display with a 1000 watt midrive dcp18 but does have the green mode eco symbol so I can change to sport how do get this on my screen I push +button but does nothing
You hold it for 3 seconds. If it doesn't work, your controller might not be programmed for sport mode.
@@bakcou thanks as my screen doesn't have ECO on left side pedestal ass 5 is like turbo
You should buy a display with a sporty position
...it doesn't show battery info while you riding. It only shows battery info if you use a Bafang Battery Pack. :)
It does shows the percentage left in the battery as you ride on our models.
We don't use Bafang batteries.
That’s correct. The percentage or overall voltage is shown in the upper right hand corner. I can be wrong - I thought while you show the Battery Information/ Index menu you commented „ ... gives us all the information while your are riding“. Unfortunately this menu has no information if a non-Bafang battery is used.
Anyone know how to reset? Having issues with "Throttle error"
hey why ur pedal a only go up5 only mine go to 9
Good question! I wanted the 9 levels but got this pos with 5 levels and eco/sport.
Didn’t buy from these guys so can’t blame them.
Folks battery information does not display unless you have a complimentary Bafang battery. Otherwise as shown 2:32, there is NO battery information displayed.... ever.
It's not only bafang batteries, the bike needs to be wired correctly to the controller. The discharge connection on the battery also needs to wired to allow communication with the bike, then you will have all battery information on the display. Our 2020 models will all have full battery information available in the display.
@@bakcou hello and thank you for all this helpful information.
would you have links to help me in my research?
Thx a lot.
ask the big QUESTION.. "Why are these reviews always done inside or in the shade..?" answer: you can't read/see them outside. Bafang doesn't see the problem in a display you can't see.
Thanks for your input, but these displays work great in the sun... we do the demo indoors for convenience. We have other videos of the display outside.
Qualcuno mi potrebbe aiutare,mi chiede la password admin.
how to reset the code 1919
Exc
Hi .. How do I remove the speed limit? What is the password ?
Not sure if there is a general password. It should be unlocked if it is stock. You could possibly order a new display and then change the speed to 40mph
Are all the bafang display units interchangeable/plug and play?
I have the DPC 11 and it won’t let me change my speed. Hoping that I can just by a new display and sort it out...