- Видео 14
- Просмотров 31 579
MiStCl
Добавлен 2 янв 2012
Siemens HB84E562B Microwave Abrupt stop and Resets microwave clock etc at 22s left
Microwave heats but stops part way through timed period, not the same point each time (see other video where it shops at 17s but can be repeated). Sometimes if repeated it will just abruptly stop and also resets clock to 0:00 as shown in this video.
Просмотров: 232
Видео
Siemens HB84E562B Microwave Stops at 17s countdown
Просмотров 1839 месяцев назад
Microwave heats but stops part way through timed period, not at the same point each time. Here it stops at 17s and resets to 1 minute. Sometimes if repeated it will just abruptly stop and also resets clock to 0:00 as shown in other video.
AEG T61275AC Protex Condenser Tumble Dryer drum not turning Error E50
Просмотров 31 тыс.6 лет назад
In the middle of a cycle the drum when the drum periodically stop turning it sometimes wont start again on its own (but will if i press the stop/sart switch) and then eventually gets an E50 error. When it does start I notice that immediately before starts there is a click (like a relay), but when it won't start there is no click. Pressing the start button will get the click and a start. The cli...
so how do we fix it
I got a technician out who replaced the magnetron and removed the heat shield. Cost £120
My belt needs replacing on this model - how easy is it to replace, as i assume you need to remove the drum to thread the new belt replacement through?
E50 mean moter not turning or software promble.
It was the 7uF motor run capacitor I replaced on my AEG tumbler. I searched for my order and it has the description & part number "Capacitor for Tumble Dryer 1256417013" I bought from fiyo.co.uk. www.fiyo.co.uk/capacitor-for-tumble-dryer-1256417013. It's been running fine since May with the replacement capacitor for less than £10 shipped.
Hi DeStMi, i have the same problem with an identical Tumbler (Electrolux TW L4 E), only click-noise, no turning of motor-drum.Do i have to replace the big capacitor mounted below the Motor (18 uF, 425-475V, Diameter ca 40mm, length ca 70mm) ?thanks & regards
Tested 7 microF motor running capcitor and found no building resistance when swapping polarity. (Check safety steps needed re discharging capacitors) so ordered a new one and that seems to have solved problem as it's now completed a full cycle. Hope this helps someone else as it suprised me that the run capacitor would give these symptoms