Видео

Hey we are trying to work on a lindy forklift with a deutz 913 3 cyl and we are having a tough time with timing it. It hazes white smoke but wont start after the pump was rebuilt which it needed badly. We are unsure if we have pump timing way off or what. Wondering if you had some advice

I have this same infector pump on my old Case 680CK Backhoe, the fuel rack is stuck and wont start. Does anybody know how to get it unstuck. I have the shut off pushed all the way in and when I work the throttle lever manually I can feel the rack trying to move ever so slightly when I stick my finger in that access hole in the front of the pump. How far should the rack come thru that hole when the throttle is fully open. Its probably about a 1/4" back in that hole from the front. Please help the tractor set for a long time but it ran good when I was using it.

We've been waiting 10 years for part 2

My rack was stuck and the engine ran away. Luckily I was able to choke it down. Thanks for teaching me how it worked so that I was able to free it up and get things working again.

What is the title of the Service Manual you are using?

Best video I seen so far. This type pump far as I know just required the oil to be drained when the engine oil was changed then you removed the top breather plug and put in a half pint of fresh oil again. I would like to find out what seal fails that allows diesel fuel to mix in the lubrication oil and eventually runs out the overflow drain tube.

Mine doesn’t have that little oil port in between the pump and block. Any idea how it get lubricated

Will you make a video on direction and procedures for adjusting the altitude adjustment screw

Help me ! The two middle pistons no longer descend. How can I solve this problem please?

The two pistons in the middle no longer go down. How can I fix this please?

I need to know how to time the pump an the motor though to make it run

Hello there, could I use a part of your video for my cold-starting compilation? of course I put a link to your original video in the description, increasing the original’s popularity too. Thank you for answer in advance :) Is that a block heater or oil pan heater plugged in?

Hello there, could I use a part of your video for my cold-starting compilation? of course I put a link to your original video in the description, increasing the original’s popularity too. Thank you for answer in advance :)

Hello Greg I have the same injector pump control rack was stuck I got free but now my tractor is over fuelling causing it to over heat as it’s a deutz how do I cut back fuel?

Sir we have some books about Bosch Reply plz sir

from where can I get shop manual, soft copy download.

I have one that won't shut off unless you push that plunger down hard by hand. Is there a way to adjust this so it shuts down easier?

How does such an engine advance its timing, under light load or high speed? Like old-fashioned petrol engines, using vacuum or centrifugal advance. I can't see any way to do it. The injector camshaft is fixed.

How does such an engine advance or retard its timing, in response to load?

Diesel expert here, not familiar with this model but, I would be willing to bet at that temp using remote start your glow plug is not getting the proper time it needs to do it's job.

Slm cv

The 6 cylinder pump is it also self lubricating, or do i need toe put some oil in the pump?

Good

Please please continue,if you can, prestrok, phasing , calibration, governer adjust ment, in return ,I pray God to give good health and bless with nesessary things. thank you . love from India.

Vvv nice g

غ

Good job vvv nice

My whatspp number 03043145928 call me plezzzzz

nic

I was looking for the rest of the videos on this pump. Was wondering if you ever figured out how to adjust the torque capsule above that altitude screw.

That altitude adjustment screw I call it the county fair screw. So that rubber o ring, good thing it is reusuable so you can turn that screw in when you get to the fair and then turn it back out before you get it home.

Could the shut off be gummed up enough that the engine would crank but not fire? I have a 930 Case that's been sitting for years. How does one go about loosening a stuck shutoff??

सर मेरे पास महिदा 575 di टॅकटर है mico का पंप है तो ड़िझल ऊत्तर राहाहै ऊसको ठिक करना है प्लीज सर

Which pump is this one, please.

Pony motor sounds like a Simca sports car!

Thanks man, just taught me a lot in a short amount of time. Cheers.

Repairing full video telling sir Plzz

Bahut axh vidiyo hai sar g

So the small cover on the back had two adjustments, the smaller one provides more fuel essentially "turning it up". What does the larger adjustment do?

Good video thanks, is part 2 available to watch please?

Supplementary idle screw setting

JCB 3DX Kirloskar 4 cylinder line pump fuel setting video please sir

ईनडो फारम टेकटर 55 हासपाळ है तेल कीतना घनटा खाएगा रोटर मे

To bad they didn’t make it in AWD that would be a home run grand slam........

DEF FLUID (2 pack) of 2.5 gallon jugs for $7.00 each - FREE SHIPPING!! www.walmart.com/ip/DEF-Diesel-Exhaust-Fluid-2-2-5-Gallon-Jugs/837857789

Call me 6239457557

Send me contact no

good

Where can i get it is part

Where can i get it is part