Видео

Baumbach Plaza

Spencer Spur

Hi Ben, I have downloaded the sppech2tect file in Matlab but how can i get the json file that you showed in other folder?

Keep sharing knowledge ❤

Loving your videos. Can i get this VI?

can you upload the video of this test? How did you excite the plate ? with impact hammer or shaker exciter ?

Thanks

💐 P r o m o s m

What file or fem 3d modl does siemens accept?

Thank you, Ben.

What is that laser ? Pls give me a source for reading about that

Loved both videos. As a distributor of SAM hammers in USA (Polytec) and personally a student of vibrations, I found the content very informative. We will share the link to your videos with our customers who can use it as a quick start guide. Thank you Ben.

hello Ben, i have 170 runs that i need to export, getting in my local the same folder name for each run as in simcenter and in them all the respective channels in wav format.. i understand how i can achieve this from your video, but you probably agree that it is a very tedious task.. i have seen i can export the whole project and get an ldsf file for each run.. i am wondering if i could use matlab or another tool to loop through each ldsf and export the wavs? or is there any way at all to do the export automatically from the simcenter? eg. creating a rule of exporting to apply to each run..thank you in advance!

What exactly is meant by a "synthesized" FRF. I understand most of the data is compared to a summarized FRF in PolyMAX but still unsure what exactly is done to the data when it is synthesized.

Can you provide manual of this calibration vibrator

Hii sir

thanks for your explanation! just wonder how much does this set cost?

Thank you for this great series of videos. They helped quite alot, especially with getting familiar with the software. How many measurement points per cm2 would you recommend to get signifikant results?

💪 pr໐๓໐Ş๓