- Видео 58
- Просмотров 216 101
Hyde's RV and Boats
Добавлен 21 мар 2016
New and used boats, Qwest Pontoons, Paddle King compact pontoons and Pedal boats, Hotwoods compact pontoons Yamaha Outboard master technician certified service
Видео
Checking charger output. Minn Kota 440D or 220D
Просмотров 747Год назад
Please review this video to be sure your charger is doing what it should be.
Boston Whaler 15 Super Sport Overview
Просмотров 1 тыс.3 года назад
Please Contact us for more information: Boat is for sale 7-29-21
Boston Whaler 15 Super Sport. Test Run & overview Part 2
Просмотров 1513 года назад
Please Contact us for more information: Boat is for sale 7-29-21 Update to video- 120 psi in all 3 cylinders - ( video states 2 cylinder motor )
Minn kota Edrive battery wiring with Solar charger
Просмотров 3793 года назад
Minn kota Edrive battery wiring with Solar charger
2018 G3 150 T- 40 Hp Yamaha EFI - For Sale
Просмотров 1,1 тыс.3 года назад
2018 G3 150 T- 40 Hp Yamaha EFI - For Sale
Gill Getter 615 with Minn Kota Edrive
Просмотров 6003 года назад
Gill Getter 615 with Minn Kota Edrive
F25SWHC F25LWHC Yamaha Outboard Operation
Просмотров 38 тыс.3 года назад
F25SWHC F25LWHC Yamaha Outboard Operation
Yamaha EF2000is Inverter Generator Operation
Просмотров 17 тыс.3 года назад
Yamaha EF2000is Inverter Generator Operation
you had mentioned you'd make a separate video on the oil? I didn't see it on your channel, anywhere you could point me to to find that? Got a generator used and it looks as if oil leaked along the inside bottom. Currently trying to clean it out as good as possible, just not sure what I'm doing to be honest... thanks for the help!
Hola el mío recién puesto ase lo mismo que se puede Aser corregirlo con la compu
my 2019 Yamaha 200 sho owners manual call for Yamalube 4M FC-W or 4 stroke motor oil. It does not specify to use Synthetic Oil like you mention in this video. I plan to go to Synthetic later after I get some hours on the motor to make sure the motor seals first.
Che olio motore metti ?
Thank you very much for the video, it has been a great help to me, very good explanation of every detail of the engine, a big hug and you have a new follower👍👏👏👏👏
Do you see bushing failures more often when a tilt stopper is being used verses a traditional transom saver that goes from the lower unit to the trailer?
That 25hp 2 stroke outboard sounds really awesome. Thanks for sharing.
Hi do you know if the fuel filter should be full all the time (mine is draining and not filling back up somethings )
Hands down the best video out there- learned so much---thank you
I'm always encountering hard to start
Hi I have a problem with mine it will not exeed 4rpm I changed the fuel line from the tank to th engine it was full of crap could the fuel pump and injectors be dirsty as I found degree from the fuel line in the filter bowl a lot of it lol thanks
bmg rights
BMG
Конструкция этого мотора похожа на YAMAHA F 9.9 JMH.
Nice and clean. My edrive seems to loose power on one battery and the previous owner added a separate charger but it never fully charges. I think I like your set up better. That charger is available where? I can’t seem to find it online. Thanks again.
Your my hero
my 2016 60hp ct is doing the exact same thing! im taking apart the fsm to check the screens inside, i also may do the iac solenoid valve
I’m trying to research whether to buy a new merc 60hp ct, or Yamaha 70, and it looks like there are a lot of merc problems?? Any suggestions, or where I look to know? The Yamaha will be 1,500 -2000 more..
considering your talking 60 hp merc vs 70 hp yamaha. your not comparing apples to apples on price. i would always get the biggest motor you can afford. that being said Mercury's are king around here. not many dealers carry yamaha parts and or service them. i can go to 10 merc dealers within 45 min of anywhere im at to get mine serviced. i have had little to no issues with my merc in 7 years. one thing to note is merc under 75hp is made in china. the best advice i can give that i got is look at the dealer network in your area for servicing and getting parts.
Thank you for the help. I like Mercury dealer near me, and I know they will be there for me as much as possible if I purchase an outboard from them. Yamaha dealers and service are much, much, farther away and I’m not sure how easily it will be to find help if it is needed..
Great video and explanation. Could worn out bushings be the cause of my engine wearing on the engine bracket on the starboard side when I trim up and down?
I changed the mother board on my e drive because it wouldn't raise or lower. I didn't take a picture of the wiring. Do you have a pic to share?
Do you idle it all the way up before you run down the lake or does it matter?
Why are you using the muffs when there’s a garden hose connector right at the motor?
That’s for flushing the engine
Good stuff. Everyone misses this
I have the same generator. I think I bought it around 2016-1018. Tested it with Coleman white gas. Worked great . Welcome to April 2023 . Bought more Coleman gas to retest the generator. Started on the first pull . Coleman white gas is $ 14 a gallon today. Great gas Great generator . I keep it for Hurricane season .
Thanks - Great help- just purchased 25 HP Yamaha outboard
When putting it back together as soon as I put lower unit back on it puts the motor into forward. When everything is back it won't let me shift gears
Make sure the lower unit and the shift handle are in neutral. As you slide the lower unit up you will need to thread the shift rod coupler together as you push it up the last 3/4 of an inch.
hi, my shift rod coupler is seized, do i need to take the rod off to un seize or is there a trick to doing it in place? thanks jf
Thank you. I just got the f20 2019. Very helpful. Got a used one with one hour on it. I didn't believe the guy (or should I say I doubted him) but according to the manual you drain the oil if transporting laying down. We drained his oil and it looked brand new. I now am a believer.
I have just purchased this engine not tried it yet however I noticed when I was walking round the engine familiarise myself with this model it would not go into reverse gear when not running is that normal? It wine into forward no problem
short simple love it. got one from a friend the other day.
What was the purpose of this video?
Thank you so much
The title suggests tying solar power to a Minn Kota battery alternator, but you make no mention of that at all, what gives?
Thank you for the explanation 💥
Zę êzçüçhå çômô måqüįńå dê låńçhå êzê mõtôr 😵😵😱😱
Do you have to ground these?
what is the name for the devise you plug the water on?
Do you start on 1 and switch to all while running? Or start on all initially?
Who makes this disconnect? I went to the Minn Kota and they do seem ti be aware of this. Makes sense though.
This one is by Blue Sea Systems or somtimes packaged by Sea Choice. Minn Kota also makes a similiar style . Some only have the arm to reset the breaker while this one has a button that can be used to disconnect the power.
What are the ratings? How many amps and volts?
I have one of these on my e drive but didn't know I was supposed to push that lever before I charged my batteries. I used it last season and this season I went to use my boat for the first time and it appeared to work and then all of us sudden the motor just quick working, it slowly lost power first...then just stopped. I plugged in the chargers and went out this morning and the motor worked again! really confused on what's happening. Thought it was bad batteres but the trim motor and indicator worked on the controls. ?
How did you find out how many hours it had on it?
Hi. So is the motor wired in a 48v sense? Looks like jus ur + is to u one battery and - is to your fourth battery? Is your batteries wired in series?
Yes- 48v System 4x - 12V batteries wired in Series
Thanks for Getting back to me. Do u happen to have a diagram of your battery set up. Trying to figure out something’s on a boat I’m working on
Excellent!
thanks**
boa tarde meu motor mercury 60 fourstroker nao refrigera já olhei a bomba e termostatico e após tirar a rabecão e colocá-la não consigo enganar ou desengrana oq fazer
Looking for a motor like this to purchase
Melody pieces traducir en espanol
ruclips.net/video/vqjwwuhi1Iw/видео.html
rtech CNC bushing solves all problems, All bushing on the outboard is injection-molded and has a short lifespan.
Still for sale
nice review. you should be a yamaha sales rep. your tempo is perfect.
thank you so much for this video. You answered my main question and about 5 that I didn't know I had.
The bushing should be longer and stronger. Yamaha bushing is weak.
You never showed that motor