Видео

I thought the radio mic sounded the best

Looking at ssb. \cb radio to set up use car mobile.

Stick with the standard mic, as the others sound distorted.

When using the kpo mic should you switch dynamic or EL ?????

The KPO DEFINITELY.THANKS FOR DOING THIS TEST.

3 years later....but I would say when coms are clear, the Cobra mic is easier on the ears, and over all clarity is better due to the deeper tone. If you are talking skip with a lot of back ground noise, then the K-Po's sharper tone will then make that one easier to pick out. Just my opinion

it's simple, can't you see that it doesn't have the power turned up to maximum

RF power level???

I had erratic high SWR until I grounded the outer coax via the mount to the car body..however that was not a Mag Mount.

HI. Where does the programming cable connect? There is no USB input on the back

CRT SS 7900 in export mode, the M7 easily goes up to 40w in USB

Turn up Mic Gain on Standard Mic to compeat better with the power Mic's, then see what happens?

did you change the mic setting from EL to DY or no??

Dziękuję za film, mam zamiar kupić takie radio. Pozdrawiam z Polski i wszystkiego dobrego dla Ciebie w Nowym Roku !

Would have been great if we could see what you were doing. Most of the time you could only see the back of your hand. 🤨

Iv just bought a crt ss7900v but it hasn't got 11mtr on it, iv widened the bands to 2 band but I can't get it to sink with the uk cb band.iv ordered a download cable from Knights and I'm hoping there's somewhere I can find some help online to help me sort it.

I like the sound of the K-PO

Where can we get the Kpo mike? Can we get them here in USA?

Thru experience the CRT range on FM and ssb especially the mic gain in the radio needs lowering to about 12/15 with any power Mike..... Try it the clarity does so much better.... Using both gains high just don't work.... Usually but not always...!! Lowish Mike gain on radio and 25% to 40 % on the Mike is best.. all Mick's are a little different.. the kpo powered and unpowered are quite good if IF your carefull with the radio gain..

İ have both of the CRT 7900 V Turbo and also the CRT SS 9900 V4 and both these radios İ highly recommend!

You can change the 7900 on the front left bottom display to your own call sign as I did, but you do need a programming lead to do so. Its a very nice radio to use, the best is the CTSS on board to get the repeaters.

M-7 mic is not good for Side Banding, I even tried drilling out the hole to 5mm but it didn't make any difference. Admittedly I do have a deep voice.

Nice job. How does that antenna compare with the basic Sirio 5000 base load configuration??

Le K PO NM 532 est très bon !

just caught your video ,, very kewl!! from one C.T. member to another,, cheers and beers!! 2CT057

Hi. KPO seems to be better for DX because with more treble. Cobra is not very good, sound is bad. Test a desktop microphone and adjust moderately the level . I use a kenwood MC80 with an old President Lincoln, modulation is very clear. Astatic microphones have a very treble and metallic modulation, it doesn't match with my voice. 73

Cobra set at 6, but 6 out of what? Geez mate!!

The K-PO to me is much clearer sounding and better microphone. I wonder what the Astatic 636L would do on that radio ?

Have you ever considered the amount of channels you could bleed into using a over driven power microphone…my opinion is there is far too many transceivers that cannot reject close channel interference from this type of microphone …one thing worth remembering there are electronic engineers with a greater knowledge than the sum total of all users who design these transceivers for optimum performance …if you are quiet on air simply turn up the the gain in the function settings and save you money for a few beers instead ,after all you are only repeating what the transceiver is capable of doing itself…only saying 🤔73 ps….the CRT ss7900v is probably the best 10/11m tranceiver on the market today with a 5k shift and good 5 level digital noise reduction producing a decent output around 60w

In the states it an Anytone 5555

K-po does rock

I've noted that the CRT SS-6900n V6 seems to have some spurs, about 2.5MHz either side of the fundamental frequency - in SSB mode. Have you seen anything like this with the 7900?

my 10 amp runs it

Thanks for the demo ! May I ask where can i get the conversion mic plug ??? Thay are not easy to find .. thanks If you sell these conversion plugs " Adapter" I will buy one from you ...

Mike I might be wrong but I did see a video about setting up the deviation potentiometer inside a rig when used with a power Mike and I’m pretty sure it was the 7900!!!!!! Zollie TE701 - M6ZPS

Hello I have a question I have this radio and it says maximum 10 amperes on the back so I got a 15 ampere power supply but no matter if I have highest power, the radio only draw 4-6 ampere I don’t understand why so low.

I have a question, on hand D my swr is good, around 1,4 but if I change to any other bands the swr is sky high. What could be wrong?

But what is the swr meter at? I just see one staple but not showing the actual number

Hi Mike - do you have a microphone wiring for your adapter thanks

Hi Mike - do you have a microphone wiring for your adapter thanks

I love the loud rock to muted speech transition lets me adjust my volume as I watch lol

I think that KPO sounded better because it also had a high pitch. In others, the voice sounded stuffy.

The Standart and the KPO the Cobra is not so la la

Thnks for the vid. Can export mode be enabled by pushing some buttons?

I got a new highgear and it doesn't work... all it does BUZZZ

How come you have PLC QRMcout there in the green?

With the cobra power mic it starts already clipping, the KPO is even worse, and the 50Hz humm is annoying. KPO and cobra on sideband are TERRIBLE, anything else than "pretty good". I suggest you're having your ears checked. Why don't you test them on FM ??? AM and even worse SSB has no decent audio anyway.

did you save the load in nanoVNA Saver? thanks for video 73s FN77

Fun fact: This transceiver covers 12, 11, 10, meters, 24.715Mhz to 30.125Mhz Please make a note of it.

Hi. I'm new to all this.. I have a question. I have the "Sirio fighter" Its hard mounted to my van roof. I can not SWR this antenna testing it with a multi meter it has a short from both the centre pin and the outer thread connection. The antenna has the removable thread/wing nut fitting so that the antenna can be removed. My question is.. If the coil and the whip are separate how do the two stay separated when the removable connection is a solid casting.. as is the part fitted to the van roof.. with two wire connections to the radio? this is my short obviously. ( I'm new to all this ) I would appreciate advice from you or anyone that can work out what i'm doing wrong. Thanks in advance: