Видео

Look closely below the three dial of the lock, when you try to peek into the lock dial from bottom and try to rotate 1st disk you will notice a sign below one of the number, once you notice a marking under that number stop the disk and do the same steps with second disk( when a marking appears below the disk stop rotating ) and do the same with the third disk. Once done you will notice that now when you look from the bottom all the dials have the marking in the front. Now follow below steps. 1. Try to pull the release switch . 2. If it does not open , turn each dial number clockwise. Try to open again. Repeat this process unless lock opens, at some random number the lock will open then you can follow steps shown in video to change the pin. Hope that helps.

​@@innovatorshub man, it was 009. i thought to my self, fk it I'm trying every combination, and it was 009 lmao

Han, bas aap poori steps follow kijieyega. As shown in videos.

@@innovatorshub ok

I would recommend to use a vacuum cleaner and a low power pressure washers to get the dust cleaned up in honeycomb pad.

For real. It's the worst in the world.

I am very sure Voltas didn’t even would have tested the product after they designed it. It is the worst design in the world for sure.

​@@innovatorshub i have a crompton cooler and it costs me around 10k but the water distribution system is the most bizzare design and with too many screws going here and there i have to open it up every day to resolve the water flow issue but its keep happening

No doubt. I bought it after seeing the TATA brand but found it very fragile and nowhere worth a DIY try. Yet, I did it. Water started coming out from rear side but not on side windows. I tried again and later found that the water is not being lifted by pump fully. Someone suggested that dust must have gathered around pump area or in its mesh. Cooler's structure is so clumsy that I guessed that I could lay hands on pump only after destroying some more things. Just nasty..😡

​@@innovatorshubThat is what I too realised afer my first encounter with its anatomy. 😂

1. Inclination feature is not available. 2. My entire family uses this trademill. I had no issue running it continuously for 1 hours at speed to 6kmh. The belt does heat up but that is not an issue because you won’t be running barefoot on a trademill. My family is using it for an average of 3 hours a day since last 3 years. 3. Not sure about the noise but I think it would be more than 68db for sure. The high speed noise is evident. Conclusion:I would definitely recommend this trademill,.

Let me know if you have any further questions. Thanks for watching the video.

@@innovatorshub Thank you for your reply sir.🙏

Mera b same issue h apka hua shi

Apka hua shi

Thank you for sharing your valuable feedback! Glad to hear the video was helpful.

Use toothbrush in that case.

Glad to hear the video was helpful!

Thank you for sharing your valuable feedback. It really helps to keep motivated and supply these types of videos.

Wo blink karega but prints aa jaynge apke.

Thanks a lot for watching the video and sharing your valuable feedback.