Видео

Thank you for sharing 🙏😊🙏

Best video I’ve seen on how to do this - clear as a bell, thank you!

Thanks for the information. Now I have a light and switch in my loft

Smart guy thanks

Thanks. Saved me a few Bob.

Thanks great advice and detail 👍

Pity you couldn't have categorised the video

Thank you so much. My switch wire came out and after I watched your video a managed to put it back again. 💥💥

Thank you!!!

Hi, excellent video. I have a question? I want to feed a small set of LED strips under some shelving and have the 12V transformer. I have identified a 30a 3 way junction box in the ceiling above which feeds the lighting circuit. Can I add a 1.5mm able to this and feed this to a fused spur > 12V transformer for the LED strips or should I stick with 2.5mm cable from the Junction box.

well done 👍

That was brilliant thank you

Brilliant just what I needed and it worked thanks for your tutorial 👍 😀

Due to risk of damage in a garage, especially if DIY jobs done there, I would not be using plastic boxes and face plates. I would be using something like the MK Metalclad switched fuse spur.

Please show how to wire two switch light (landing light ) thank you.

Good work

I need to know how to do the set-up WITHOUT a cell phone.

Hiya ! I have one of them in my Attic and not working would a 13amp blow it? I think the fuse went and it was a 13a I put another 13a in but never worked I am in Scotland so same electrics as you not Europe.

What would cause it to start bussing room flickering On off

i have taken a double spur from ring circuit and fixed a 13amp geyzer switch to it and used it to add 6 extra double spurs for my items of aquarium tank including heaters filters etc..and wired them with 2.5 wires..i did ok or not??

Hi. Very good RUclips learning. Please advise if i) a switched fuse spur for a boiler should be 3 amp or 13 amp ? ii) if the former, would it be ok if the fuse spur's 13 amp be just replaced by a 3 amp fuse ? iii) how come my switche fuse spur just has one hole for Earth ? Many thanks.

Good vid. Is it dangerous to rig a light straight from a 3 pin socket to a rocker switch and then to a ceiling light bayonet holder, or is it best to use a cable from the 3 pin socket to a SFS as the light switch. Thanks

NYM-J isn't rated for exposure to direct sunlight though, you might want to paint it for UV protection or - if you're watching this video as a tutorial - use black NYY-J instead.

How come your using a fused spur for lights

hi, would it be possible that you choose one tool during each video and explain what it is and its use...kinda a tool of the Day feature? Just a thought ..Great videos...

My unit say sensor fail and beeping

What didn’t you just put the cable through the back of the socket?

Just what I needed must be psychic thank you 😊

Quick question. I have a fused switch fitted and second wire goes to outside light. I want to change light and run a new cable. I removed the fuse and cut the wire. Do I need to turn off electric when I’m fitting new wires? I know it’s dead as I cut the old wire but is there anything live if fuse is out when fitting new wire?

Nice video

Work that screwdriver !

My Man!