Видео

I guess I'll have to do it again!

As far as I know they are not compatible. I haven't tried myself as I don't have a 1.0 but I do know the design was changed and they are different sizes.

Yea! DC current works relatively well with water. I should say it's the same water resistance as normal.

We got it used. I think the previous owner swapped the motor with a smaller one.

@RebuildRC-1843 that's exactly what happened to me..wasent sure cause every few passes it cuts off..did urs do the same?

Hey, thank you!

@@stogie0608 Not at all. The original spring is actually linear, so adding a spacer just tightens things up a little bit and gets rid of the slop. Traxxas actually makes a stronger spring that is more aggressive than this alteration.

@@RebuildRC-1843 ahhh understood.

Are you able to check voltage per cell? You need to make sure you don't have a cell that has dipped too low.

@@일기장-r2l thank you!

Usually when a charger rejects a battery it's because it's under the threshold voltage in one or more of the cells. Very rarely a battery will voltage soak and be overvoltage causing a charger rejection. I would advise you take the battery to a local hobby shop and have them test the battery. Sometimes batteries can be brought back if they're too low but it can be relatively dangerous if you don't know what you're doing. To be absolutely safe I would store that battery in a Kevlar bag or an ammo container until you get it inspected. It could also be a bad connection somewhere or you're simply making a mistake. Without seeing it I'm not exactly sure. I would play it safe and have your setup inspected.

At the time I took that video the only thing that was not stock is the body and I had the Hoons silver tires on it. The only thing I've done to it since is change the viscosity of the differential oil. You can see a full rebuild here: ruclips.net/video/npwrwrFPH3A/видео.html

@@RebuildRC-1843 ok thanks ☺️

Thank you! I had a lot of fun recording and editing it. I'm glad you like it.

Sorry for the delay! The truck is stock. I don't know the original oil weights, but I'm using 35 weight (425 CST) in all the shocks. I believe I'm using 50K in the front diff (may be 30K from factory) and 30K in the rear (was grease from the factory). I'm happy with the runnability. I feel like I have a bit more control over the truck in a power slide situation, I assume due to the tighter differential oil. Hopefully that helps! Thank you for watching!

I'm glad you like it! The cost of ownership for an X-Maxx actually isn't that bad. However, buying one can be expensive. I get all my trucks used because, in my opinion, they'll only look new for the first run. It's a great truck and super durable. Good luck getting one!

Thanks for watching and commenting! I don't have a lot of experience with 2wd trucks but I do know a lot about batteries. First make sure your ESC has a low voltage cut off and it's activated! Super important! I would go with a Lipo battery for best performance. In a nutshell the largest number advertised on the battery represents how long the battery will last. A 5.0 AH battery is a 5000 MAH battery. The larger the rating the longer the battery will last. C rating is going to be the punch that the battery provides when you spike the throttle. Generally the higher the better however in a two-wheel drive application that may not be the case. The "S" is a cell count. So 2s is a 2 cell battery and a 3s is a 3 cell battery. The more cells the more power. In my opinion even on the four-wheel drive trucks 2s is plenty of power. 3s starts to be uncontrollable and breaks a lot of parts. That's obviously an outline of what the numbers mean. I would encourage you to check out some RUclips videos on the subject if you'd like to learn in depth information. Maybe I'll make a video! Personally I like to run 2s LiPO batteries, 5000 to 5500 ish MAH, 35c or better batteries. A lot of the off market brands misrepresent their C rating. That's a likely reason that Traxxas batteries have a lower C rating and some of the other competitors yet they perform better. Hopefully that's helpful!

@@RebuildRC-1843 thanks I got some 2s 6200mah hovoo batteries they work great on the 2nd and I’m looking at a 4x4 vxl so should work good on that too!

Perfect! That extra MAH will give you a good run time!

@@RebuildRC-1843 I got the Vxl yesterday and it goes for around 40 mins at a skate park

That's great!

Ok. Ty.

@@RebuildRC-1843 np

It was a lot of fun to make. I'm getting better with editing every day. Thank you for watching!

Do you know that because of the noise? I was thinking the noise was due to having metal gears. I will definitely research gear mesh. Thanks again for the comments and for watching!

I did some research, and you were right. I had to replace my gears and set them by hand. Now, it works and sounds a lot better and produces less heat. Thank you!

100% necessity.

@RebuildRC-1843 I swapped out the stock system for the Max8 2,250kv system. I definitely recommend if you're going to upgrade in the future.

Do you have a video on the RUclipss of the swap?

I agree. If that truck is run on 3s it'll definitely break. I'd like to get a mini Maxx to see if the durability is better.

@@RebuildRC-1843 lots of people put tons of power into minis. try it

Hey thanks!

If you watch around 1:01:30 I powered it up with the servo horn connected. It tried to turn hard to one side and destroyed it. The gear that's on the output shaft of the motor ended up spinning on the shaft. I don't know if that gear is pressed on or how it's fastened to the motor shaft. To my knowledge it's dead. I'll probably take a look at it eventually.

Most adapters I've seen on the Internet are for charging only. Make sure if you buy an adapter it's rated for the intended purpose. You may be better off installing the correct connector. Your local hobby store may be able to help you if you can't install it yourself.

@RebuildRC-1843 thanks very much for your reply,I'm sending the spartan back ,bit too much muck around, just want to plug an play

I was wondering if I could put the X-Maxx fan system on the Revo. That fan system moves a ton of air.

If you've never had the chance to try a properly fast on-road RC car, you'll absolutely love it . Maintenance costs stay low as long as you keep all four tires on the ground. I've had a few clutch issues, but nothing too serious. However, aggressive driving really takes a toll on tires. Typically, I only get about 10 packs out of a set before they fail. By the eighth pack, the tires are effectively worn out. I plan to conduct a few tire tests later this year. Hopefully that helps.

@@RebuildRC-1843 just got my first rc car a couple weeks ago it’s the hyper go h14bm goes like 50 it’s a 1/14 scale. Messed around with my brother infraction 6s and loved it. But the price range a little to high for me so I was checking out the 3s

I buy all my RCs used. It's a bit of a gamble but I like to tinker as much as I like to run them. Sometimes you can find a good deal on a used tested vehicle at RC shops as well.

Thank you!

Dirt is the one thing that I don't clean off my RCs!

@@RebuildRC-1843 why

They look better dirty

Thank you for watching! Just a heads up! It's not a fun project and it will add weight. I feel like in the end it was worth it on the X-Maxx but your mileage may vary. I'm not saying don't do it! Just being transparent with you. Thanks again for watching!

How did it go for you?

I would encourage you to reformulate your comment unless you can provide definitive proof from your own testing or a manual that the way I have the limiting straps installed is wrong. You can check out videos from MSM and Outsourcedrc on the topic. You can also check out my other running videos to see how my configuration is working. If you disagree that my configuration is best I'll have that conversation with you but to say it's wrong is not the way this works.

The truck is expensive but the cost to run is very low. That truck is literally hard to break.

That truck is unreal. It bent the drive shaft and popped the upper rear arm out but it was still driving fine. I have a video showing the repair if you're interested.

Little bit of crunch crunch!

If you're familiar with the Elevens you'll find that the silvers have way more grip. I think you're going to be happy with them for speed runs that said I just mess around so I'm not entirely sure what a good tire would feel like trait-wise. I am going to be doing some comparison videos between the Elevens and the silvers. I'm also going to try to maybe put golds on the front and silver's on the back to see if it helps with the understeer that my Infraction developed from the tire swap. Definitely let me know how it goes!

@@RebuildRC-1843 I definitely will be sure to let you know. They arrive tomorrow and I will be doing more runs this weekend.

I'm glad you found it! Thanks for watching!

Savage animal! Thanks for checking out the video.

Yes that will work too. Just make sure lipo protection is turned on in the ESC. Thank you for watching and commenting!

@@RebuildRC-1843 thanks for the quick reply man. Subbing

I'm a little surprised it survived that one! I have another video from the same day that it didn't survive.

ruclips.net/user/shortsnkcau0cSK54?si=9siV4c1AKJZkGqxI

Can you be more specific? Are you talking about the output shafts from the differentials or the drive cups? Do you have movement of the entire diff in the bulkhead housing?

Very little movement but yes, very very small movement but yes, they do swivel side to side a very very small space in between pots so pots don’t warp or strip or wear the against the plastic small, but limited spacing

I'm still a little bit lost on exactly what component we're talking about. Can you help?

This stuff I'm using is Lucas white lithium grease. Any kind of tacky multi-purpose grease would be fine for the pinion and ring. You don't want something too light because it'll fling off, if you go to heavy you'll have some unneeded resistance. I like marine greases the best. Special lube 101, 2-4-C or Quicksilver extreme is really good stuff. That said I don't think you need to spend big money on grease for differentials.

It is not fun. Did you do it in small sections or glob and go?

@@RebuildRC-1843 glob and go, if i did it again id use small strips instead but either was, ordered tape and will sort tomorrow.

For sure I would do small parts at a time if I did it again. I did not enjoy the project but I will say in the end I'm happy I did it. Hopefully you will feel the same way.

@@RebuildRC-1843 Thanks m8. Maybe another day

Thats exactly what I think, just get a new shell for £30 to £40 quid Ain't worth the hassle Shoogoo and dry wall tape costs over £25 ain't worth the grief

Awesome! If you need any info let me know! I can make a video on whatever you need.

@@RebuildRC-1843 will do man thank you so much🔥 you got a new subscriber👌🏽

Hi. Thank you for watching my video! I'm not sure what your message means.

@@RebuildRC-1843 sorry i Write in french +1 follower for you

For liability purposes I would say use as the manufacturer suggests on the container. My personal experience is, you can smell the product but it isn't overwhelming. I did my project in my basement. The tube actually says low odor right on it and it is made for interior home repairs.

It's good. I haven't tried the shoe goo so I can't speak to what's best. I will say I learned a lot on this project and would do it differently if I had to do it again. I would cut much smaller strips of the tape so it would lay down better. I would also maybe spray a light high tack or something to hold the tape before the goo is applied. I've seen some use hot glue. I would also use a lot less goo and or go thinner with it. Pros- definitely a lot more durable. Cons-time-consuming, not a fun job, very heavy. I'm not sure if this is the product I used or just the nature of the application.

I'll make a RUclips short of how the body looks now after a lot of bashing. I'm sure you've seen some of my shorts of how I treat the truck so you can get an idea of how well it's working.

Thank you for watching! I think I need a Sledge..

Lol

It's so good ..