Видео

Lmao all the people crying about 16K but have no idea the equipment they're looking at nor the time it takes to properly install all the equipment + sound deadener a long with the expertise that's being paid for. easy 16k

How much did this cost ?

Where do you pull power, ground and remote from to power the amp for the subs?

You skipped the bezel around radio 😹👊🏼

Wonder how much crap ended up slipping through that mesh and on to the speakers. Plexiglass over speakers would be cool

I have 1 solo Barric 15 & it sound like I got four 18’s in the trunk 😂

Do you have any shops in Central Florida? If not approximately how much to ship from Florida to California? To get my C7 done.

So you can leave the upper clips on the back seat in place and just swing it up?

Thats about what mine looked like before i took it in to get done at a shop 😂

Don’t throw the parts the customer paid for on the fucking table you tool…

I have a fourth order bandpass as well in my four-door sedan. But my port goes through the rear armrest opening and let me tell you... 2-12s on 3K, I cannot stop my car from flexing and doing mini hair tricks. Because now, all the output is in the cabin and not rattling the trunk. But you have to make sure the trunk is completely sealed off so you don't get cancellation. Plus I can sit 2 in the back with the seat up! Although I don't have the LED lights and all, this is the proper way to do a high end trunk build, good job 👍

How much deeper do we have to go for the heater core?

Ruthie Villages

Hertz is kinda mediocre bs tho for real, lets be honest here

Rath Glen

How many watts can you add to an Genesis GV70 EV before it puts strain on the dc convertor? I'm running a 1,200 watt rms class d amp. no issues yet, but concerned i may be putting strain on the dc convertor.

Did y’all do sound treatment?

Help! I can't that first 7mm bolt out by the glove box. Anyone got any ideas?

How much for a setup like that ?

Is the small 12V battery in the model Y enough to push the three subwoofers?

Thank you so much for this video. It saved me time and effort. I actually went into the IPC panel but this video was 90% of it. Thanks again

Girls must love throwing around boxes like that….

Not sure I would do this without disconnecting the battery first.

Its the same way also in 2022 ?

1 minute in and I love it already. Thank you!!😎 would guys sell the speaker box if I wanted to buy it?

I wire everything myself and if I dont like it i changed it myself.

I bet the owner did the installation lol

Will that same setup work for c5 corvette coupe

Does this tax the battery? Kill range at all? Looks bad ass!

You suck !!!!!!!!!! You ain’t should me shit on how to install a system

Thank you for the helpful video - the video was especially in describing the bezel removal. Was wondering if you could recommend the best web site to buy a replacement APIM. Especially including an accurate reprogramming included if I supply the seller my VIN number. Is this possible? Of course, I would like to avoid reprogramming..

So wyd about the under seat ventilation? It’s going to be fine in the summer but the winter your going to be blowing +80° air on that mf

Dope build

What do you call the first piece of trim you took off?

How much does this run as far as cost?

I knew when I saw the dewalt you knew what you were doing. great video.

and where goes the targa roof yet? Fits still the trunk ro storage

Hertz is OK, can't say it isn't but surely not the best and that dsp is an ic amp not mosfet which come which comes with massive limitations compared to a stand alone mosfet class ab amp for the front stage. Also focal, Morel or some dynaudio ways would blow the hertz out of the water. Not saying hertz are shit they aren't at all there is just better than the title suggests but I've got used to legit videos even using click bait now 😂

Nice vid! Thank you!

DIYer but very capable. Wondering what is underneath the portion of the dash next to the factor 4” driver locations? It sounds hollow from some taps. I want to put in a 3 way component system with woofers in the kick panel, mids in the factory 4” and then bore out the section of the dash for some 1” tweeters. Cross over will hide under the footwell. Any help is appreciated.

That’s brutal

I am not generally for bass knobs but I like that idea. I like my radio to be able to control the bass.

Yawn

No sound deadening?

What does something like this cost ?

I’ll bet the customer installed it

I would love to build the same box. Is it possible to buy the schematics from you in order to build myself?

Do u guys have a full video of everything u did

So how do you get the factory bose to send a frequency below 30hz?