Видео

Heating system should be off and cold when adjusted?

Thank you pat! Ten years on and you helped two helpless gen Z girls have water in their dingy London flat 🫶

Thank you so much if I ever meet you drinks are on me 😊

Very helpful, thank you

Helped me so much - many thanks mate

When the heating is on after topping up the pressure to 1.5 is it normal if the gage then goes into the red a bit when the heating is on?

I watched another video first and opened too fast now its on pressure past 2

Thanks so much just fixed my mine 🙏🏾🙏🏾🙏🏾🙏🏾

Thank you

Thanks man saved me 😂

Cheers mate. Bled all my radiators in my new house and pressure went to 0. Followed the guide and got it back up again in no time 👍👍

You've saved my life

Hello! It doesn't work well for me

What happens when do this and nothing happens

Cheers Pat, partner’s house is now toasty and she’s well chuffed. TY

Thank you so much for this!

Thank you so much thanks to you my boiler has started working my home was freezing so I’m very grateful

Thanks for the upload!

Hi mate I know this vid is 7yrs old so not sure u will reply, got prob wiv my potterton assure combi 25-30-36, its anew build house so must be new model boiler but cheap, can't get no heating on and pressure is below 1, I see ur pipes are the same in urs, any change you can say I do mine the same as urs? Thanks buddy

Would've been nice to see which way those valves are meant to move. Mine are stuck in place and they're weird because they look like they should tilt and not turn. It's nothing like any previous boiler I've ever used with quarter turn taps (this new boiler is a baxi and I just fitted a radiator back on)

What english r u speaking

Thanks

My boiler pressure keeps going up when turning centre heating on

Do I switch off the boiler to do this or does it make no difference. Plus mine is a potterto perfoma

Not only did you save me money, but the wife was impressed I managed to fix something!

This guy serviced my boiler several times he even cut me a length of copper to use as a guitar slide. He worked for a company that my housing association used. I’d often see him around going in or out his van and he’d give a warm hello and a funny quip. I hadn’t seen him for a while and I asked another engineer doing the service and he informed me that Pat had died suddenly of a brain haemorrhage a few months earlier. What a shame nice guy. He was only in his early 50’s. He left an adult son.

Thanks... got the heating back on. Merry Christmas

Thanks m8 - You saved us from a very cold house ! - I've just managed to add the pressure back in our Potterton Gold HE boiler and the central heating is now working A'OK once again :-) Merry Christmas & God Bless you. 👍👍👍

4.30 in the morning and house cold! Sorted thanks to vid 😃. Can go back to bed as house warms up. Happy! Thanks mate.

Your a bloody star thank you xxxx

Thanks man, you've saved me so many times! I have your video saved in favourites for emergencies 👌

Thank you so much, you saved me 200 mile journey to one of my properties.

Hi pat hoping to ask a question , I have over a month to wait on a new boiler being installed in the meantime have a very young baby so need to access hot water and heat the home, had some issues and repairs with my potterton last couple of years. ATM the pressure gauge sits too high And the only way I can have it operating and remaining at a safe level of 2.5 is too run the hot water otherwise it rises above 3 towards 4 which I know isnt good dont want to blow the valve . I Am wondering what the cause could be as renovating could it have anything to do with the cold water feed which I think is located in the attic or a underfloor/ground leak atall ? Since it's an old bought property I dont have access to free plumber and my Britrish Gas policy only covered one repair, the temp valve had blown before and caused a leak internally of which I was unaware for a good while its corroded internally the shelf I ask incase theres maybe major work needing done due to CVOID none of the government teams like warmworks work during this time so my concern is safely, If I keep the hot water flowing at quite a strong flow I can keep the pressure down just enough to operate the heating , but I only have it on for short but clearly I am cautious and sceptical about even attempting to operate it but have to heat the house and get some hot water can you advise pofterron for over ten years do you think this sounds like a more external issue than the boiler itself , ? Thank I hope you can and dont mind replying to advise so I can be prepared to expect to pay alot more towards the plumbing , Thanks Julie West lothian

Top man

Thank u so much mate. I always forget and use this video haha. Nice 1

Thank you!

What if it's up to 4 how do you put the pressure down?

I have 2 blue taps at the front- I can open the rear one behind the filling loop, but the tap at the front wont budge?? Its jammed

Hi should I do this with the boiler on or off...? THANX

does it matter which one you open first?

Thanks pal. You jusu helped out get my up and running again.

i did that and now the pressures too high and ive got in a muddle with which position the valves should be? help

My man you saved the day! Thank you so much!

🙌🏻 your my fucking hero

Cheers boss. Worked for me.

Also if the rads are on and i open hot water in the sink the rads turn off until i turn hot water off.

Hi I have the same boiler. My issue, boiler is on first floor when shower is on, on the second floor the shower in the basement goes cold this did not happen before untill my pipes froze wen i was on holiday and someone altered the settings underneath the boiler i think. Don't understand why the shower in basement goes cold the pressure is reading 1.5 bar. Rads work fine Hot water pressure is fine. Can you help me out? Thanks

Cheers buddy, after bleeding my rads pressure dropped and consequently boiler cut out. Wasn't familiar with this boiler as we have just moved in. All good now.

Thanks alot

on mine the tap on the left cant be moved, pressure is around 1 but i cant seem to fill it up