Видео

I know I am half a year past the upload date, but had a question regarding your clutch. My car(2013 b8.5 s4) is at 120k miles, and previous owner had the clutch replaced at 75k miles. I am not sure what clutch it is, but it certainly doesn't feel like it's an upgrade from stock. What are your thoughts on stage 1 Jackal tune and a stock clutch compatibility? (I understand that it all depends on the driving style and how hard you push the car, but wanted to hear any more possible input and if you've had any issues if you're on stock clutch.) I had my clutch slip once, but it was totally my fault trying to launch it up the hill. Ever since then I have never had any issues, yet I am stock tune, just got an intake and a catback. Thank you!

I just changed the spark plugs but it still shakes and sounds the same do you recommend changing the ignition coils?

These are the rs5 rotors? 20x9 et 26? Any spacers?

I'm about to have to do this on my Q5. Really made me feel better about doing this. And very helpful with how well you explained every step. Well made instructional.

Good work playa!

Ram trx is my favorite truck

what tool did you use for your drain plug

I bet if audi was to make a truck you'll probably buy it lol

Question I have the same vehicle as you.. now I feel like my starter is acting out would you know what’s causing this issue ?

Not true eventually you will get tired an sell it🤔

Took the intake off?

"Increased Aero & racing time" get a life

Yooo, that is the best sounding S4 I've found. I'm going to do exactly this. Thank you!

Where are the tips?

I got a 22 ram 1500 limited 5.7. Shits a beast. Gonna join the Audi family with with a b8.5 s4🫡

Proper vehicle bro

🤨

Do u pop a check engine light? If it doesnt pass smog?

Just ordered mine!!!! Lets gooo

Hi my friend does it fit a rear bumper b7 on the b6?

Good info, Thanks. A few things. Do has is shown, loosen the axle nut WHILE the car is on the ground. On those 12 point bolts, autozone (i think) has a package with 3 in there. They are a metal stick with the 12 point on one end. You have to put the stick in a socket. Or harbor freight might have 12 point sockets. But check for space. I did an a6 once and space was too tight for a socket. If in rust belt, clean out the recessed area in each bolt. I know you want to jump into getting the job done. But you need some WD40 or just a water spray bottle. Take a pick tool and get all the gunk out. If you do not get the 12 point all the way in and strip the splines, that is a bad day. The pinch bolt and nut are listed as one and done, ie should be replaced after removal. Can you clean it off with a wire brush and reuse it with some blue thread locker? That is between you and the car gods. And am not sure what audi specialty repair shop would say. Specs are for a 2017 2.0 Q5. Please conduct your own research to confirm. control arm pinch bol. torque 40 Nm/30 ft lbs axle nut 200nm/145 ft lb plus 180 degrees, some postings said 90 degrees. Snug up while lifted. MUST be on the ground to tighten. drive axle to transmission 12 point bolts 70 nm/50 ft lb.

Temp guage - normal 90C in the middle. Its ok 1 notch to the right but its hotter than it wants to be. More than one notch to the right, turn it off and let it cool because it could over heat if you keep going. Could be a lose/broken wire.

where did you get the red center caps?

Where did you get the buttons from?

Clear

Not so keen on the Q5's rear end, but the rest are lovely, especially that A7.

Love the little one ❤. Learning from a young age. That is awesome 👏🏼

Any upgrades on your suv and do you have power windows and backup camera

Could you list the tools needed?

no one cares for your opinioin

Audi: When you want to pay more for a Volkswagon

Nilu 27 🗿

All of them are sexy AF

Show B6 🎉

T20 M6×16...correct?

the two T20 torque screws (2 on each side) that hold the ignition harness on both sides are missing on both sides. What are the screw specs so that I can replace them?

So thinking of respraying my s4 black again

B7 is perfect for a daily

Nice job dude. Asian Power! I'm going from B8 comfort to B8 front sports seat. Do both front seat modules need to swap with the original or just the passenger side?

Thanks

Did your car stop turning on

2007 A4 3.2l

I got the same problem right now

All black/de-chromed looks great!

if you have a leak, do you think I need to tighten it more I didn't have a torque wrench? Right side leaking right over the transmission cooler

had you put any miles on this SUV and what type of trim lines

Cant find the video

working on a audi q5 with the same noise while driving on the passenger side.... did you replace control arms and did that noise disappear?? I already replaced axles

🔥

As long as it ain’t the a7