Видео

My fps is fine at bergamo although I get decent fps so dont really look at it frequently so no idea but I don't notice any low fps to anything like 13.

I got no idea. From what I know the experience on xbox isnt the best compared to PC however it's still enjoyable depending on what you want to fly and do ect...

You think that was a good landing?

Yes it was smooth granted a bit outside the touchdown zone and on Center pretty good he just needs to get it down quicker next time​@@mammid9622

I have no idea. I just use a livery from Flightsim.to :)

@@noahsimulation3879 I'll check that out. Thanks!

Yes. It's just when the wind moves direction bassicly. Happen IRL if you watch videos of it.

You can find my settings in the description at the bottom :)

The cool down timer for the engine until they can be turned off. Usually is used for single engine taxi :)

@@noahsimulation3879 ohhh I see, how long is it normally?

@ejpilot3725 3 minutes after forward idle is selected I believe

@@noahsimulation3879 alr thanks 🙏

Thank you

Thanks 😊

I use the thrustmaster captain pack and then the old logitech Pro fligjt rudder pedals

I have a good PC and frame gen with DLSS.

@@noahsimulation3879 I have the same graphics card and Ryzen 9 7900x at the same settings (also 1440p) and have around 40 a 50 fps.

@@BrixxGamez I am not sure then. Perhaps because my CPU is the X3D which has been proved to add more FPS because of something in it (can't remember what).

Yes this is the iniBuilds London Luton EGGW.

Thanks

@@noahsimulation3879 np

Thanks :)

The Just Flight LEPA :)

Thank you! The scenery is from Flytampa :)

Because the headwind dropped off before and then increased again so needed to gain the speed back.

Ah ok thank you. I don't have icing turned on seen as I know there are some bugs with it at the minute but I'll do that next time, thanks for watching!

@@noahsimulation3879 No worries, it’s a bit into the “deep simulation” part of flight sim. I also wished the icing worked better; however the fenix team have done an incredible job with the v2 update. I watched their feature review video where it mentioned that ice buildup on the engine fan blades can prevent them from spooling up, and the solution is to run them up to 70% N1 for 30 seconds to “shed” the ice from the fan blades. What do you know, just yesterday I ran the throttle up to half way for takeoff and my no. 1 engine only spooled up to 40% N1 - this was in a very rainy/snowy Helsinki where the OAT was negative. I called tower, told them I’d vacate the runway, then taxied out to a remote stand where I spooled up my engines and “shed” the ice. I then took off without issue. A very very good simulation not just from the cockpit but all around the aircraft.

@linglong3285 fenix has done a fabulous job yes

What about it?

Thank you!

After landing yes

Thanks for watching

I use frame gen but for anti aliasing I use TAA instead of DLSS and I beleive that is why

Thank you

@@noahsimulation3879 np

Thanks!

If you bind it to the autopilot disconnect on the side stick when you press it it will disconnect the AP then press it again and it will clear any warning.

@@noahsimulation3879 Thank you, will do! Keep up the approaches! 😄

Thanks! @@xenonrxsexenon8761

I use the BMOTW version :)

Thanks!

I am not no :)

Thanks for watching. Here are my settings and I don't use reshade :) imgur.com/a/NFVqe9k

@@noahsimulation3879 Do you use MSFS AutoFPS?

I do not :)

Thanks!

If you mean FPS (frames per second) then yes definitely. If I remember right i used to have about 20-30 more FPS using 1080 then changed to 1440p. Could be a little lower than that but you would definitely get more FPS if using 1080p.

@@noahsimulation3879yup appreciate it!

The Amsim Version :)

@@noahsimulation3879thx🫡

Here you go :) imgur.com/a/NFVqe9k

@@noahsimulation3879 Thanks mate :-)

Thank you!

It takes some getting used to but I quite like the way it feels.

​@@noahsimulation3879 whats differint about it? i havent been able to check out block 2 yet

@@TrinitysTalons quite a lot to be honest and I dont even know it all lol so best to look at their website

Thank you!

They have done an amazing job!