Видео

Not sure you will answer after all 4 years but I gotta ask. I have this car with 2.3 engine and I struggle to determine at what rpm ( or speed) to change each gear driving around town. 50kph is my limit and I always try to drive in 4th at limit to save on gas, but the engine doesnt make it easy, it falls to 1.5-1.7 rpm and I am not sure that is healthy for the car. Maybe I'm used to driving smaller weaker cars...

Where did you get the shifter and shifter boot? Thanks

Where is this vehicle currently located.

Did this effect the bass at all? Or sound?

hey there, is thjis with stock mid pipe? nice nb btw!

I have the same car sitting outside but I still decided that I must see this. I dunno what I expected. Nice vid!

Dang, sounds like an old man snoring.

I swear it feels so much faster in the car! lol

This has nothing to do with fuel consumption...

You just drop the pump into any water source...bucket, water container, river, etc.

I hate to be that guy but just want to say that there aren’t 3 overdrives in this transmission. 5th is your overdrive and 4th is usually 1:1 in most transmissions but in the Mazda G5P like in this particular model it’s actually 1.03:1. Just a little something I’ve learned. I’m always trying to learn about vehicles every day considering I’ll be a mechanic after college. I do like the 2nd gen shifter though that’s cool. I’m actually getting a 2nd gen with a 5 speed.

folks ok dont do this,first off he should have left the trash is his neighbors garbage, theres videos that show you how to do it the right way haha.cover all the holes in your doors yes even the big ones that were made to reach inside to work on stuff,cover them with thin metal or hard thick plastic ,yes put screws or pop rivots to hold them in place,then cover that with sound deadener ok,look for metal rods that move to open doors wrap foam around them.then on the back side of your door panel,the plastic panel,door card,they sell sheets of foam thats like 1/4 inch think or more with a sticky side,you peel and cover the back of your door panels.put your panel back on dont fasten it yet ,turn your speakers up listen for rattles if none go ahead and reinstall.this is a better way to do things,you've made your door a sealed enclosure by doing this if you do it right,also get some aluminum tape they sell in hardware stores they use it in attics around your ac ducts,use this to tape everything up with because it wont melt and come off.i could keep on but im tired good luck

Hey Jack, does it share same parts with Mazda Tribute 2002 manual transmission?

How does the shift knob come off? I know it has a pinch clamp but after you cut the clamp does it unscrew or?...

Man I want that roof rack.

Great set up , Great detailed well though video !!!

I would use a thinner foam or maybe some sound deadening material.

Too lean would be not enough fuel, too rich would be too much fuel.

i have the 2002 5speed escape and its very different in side

Hi there! is it the same transmission thats on a Zetec 2.0L? thanks.

Link for the pump?

My 1999 Miata has 50,000 miles and for the last month I've had the following 3 codes and I'm wondering if they're all related somehow: - P0300 (Random misfire) - P0420 (catalyst system below threshold bank 1) - P0455 (EVAP large leak) The car gives off a very strong gas smell, and on 3 occasions it has started up rough, the CEL started blinking, and then after a few seconds it corrected itself. Any suggestions would be helpful!

What kind of gas mileage do you get? Any known issues?

Thanks! Good vid!

Looks great man

sound you have used in video comes under fair use ... you have to just dispute

Good Job but way too complicated. Here is what I do. 1 gallon heated water inside a bucket. Use a cup to pour water over body to get fully wet. Soap Up and use a cup or two of water to rinse off. 1 gallon is plenty enough water to take one shower per person. Don't feel like taking a shower for a day or two... use baby wipes that cost 2 dollars for 200 wipes.

what if the tubes ar stuck

Great work. Wondering how you could cut the noise down from the pump. Thank you for posting!

If you are car camping, you could just get an extension cable to plug the pump into your car's 12 volt outlet. Then you wouldn't have to worry about the power bank's auto shut off feature. Just start your car for a few minutes while you're showering. I'm thinking about something like this for hurricane season.

Lol not hating.. but you could have just used some ✂️ and a piece of 📦 from something ya ordered from Amazon, and would have worked all the same.

Lovely sound and tidy car

Is that a Cobalt cat back or an axle back?

Okay here’s the question can I swap an XLS trans into my XLT?

awesome

It's a very nice one. 2wd or 4wd? Sure, I'd like to see the highway video.

What awful shifting

I have an 05 and it came stock with that same shifter

Works great for me. Thank you!

Its a good idea but they sell kits for this kind of projects. Also the door skin is not going to fit with all that foam.

yo I have the same vehicle glad found the same type easier for me

im currently trying to diagnose a gas smell in the cabin of my wifes 99 miata, so was just curious if were u smelling any gas fumes because of the bad purge valve? thanx

RUclips copyright, how in the hell are they have copyright to what you did on your truck speakers 🔊!!? I believe you but that’s a bunch of BS to me, that’s my opinion ! I don’t see how it is, anymore can use it so if I use something similar ad copy writing me ?? That’s a bunch of BS if you as me but I know you aren’t, I had to throw that in let me know your opinion on that?? I have a 2005 Chevy Silverado 1500 4X4

So glad I found this video! I have a 2007 Tahoe and I bought new door speakers. After hubby installed them, when I turn it up my door panels rattle. It sooo annoying! He said that there is nothing that he can do. I was thinking maybe putting a towel around it. What do you think?

Does it pop like that naturally or do you have to get it tuned?

Good job dude..great video!

Where do u live can I bring my car to u can fix rattling ?.. I’ll pay u

This is by far the best soundung exhaust ive seen on yt! What did you use, and where did you find those cluster faces!?

That sounds really good. Looks like you build stuff the way I do.

Is it lowered ?