Видео

Hi there If i want to become a diamond installer here in Massachusetts where is the nearest training facility and how long is a course to become certified?

Ive had my 24k btu mr cool for over 7 years in the harse Houston climate. I dont know if it matters but i had installed by a licensed proffesional. Ytd not a single problem, i guess i got lucky. Biggest challenge, is getting a contractor to service it.

excellent job... labeling is a must.. nice clean install so far... good content...Thanks

649 Rosenbaum Square

Great work like your style!… the only thing I will say is they tell you in the install manual not to put a fitting on top of a drain tail… or maybe I didn’t see it right lol correct me if I’m wrong ✌️✌️

When you added the 3rd zone did you have to remove the refrigerant before you added the linesets to the branch box? I’m adding two zones to my system

Great video. For branch boxes installed outside with the cables coming out of the top - Should they be covered ?

Great video. For branch boxes installed outside with the cables coming out of the top - Should they be covered ?

Great video. For branch boxes installed outside with the cables coming out of the top - Should they be covered ?

How does the switch move? I can't get the switch to move in any direction.

How about using double flare with a torque wrench and n i l o g blue

I'd work for yall

Can it be mounted on a vaulted ceiling or does it have to be 100% horizontal?

Can it be installed on a vaulted ceiling, or does it has to be 100% horizontal?

So what you're saying is I cant just DIY this?

Great Video!!! Best tool ever made! Do you have a recommended supplier for ProPress Fittings? Can you leave Factory Cap on Branch Box if one Zone is not used? On a 48H2i, hoe much can you go over the Rated Number and do you recommend that? I plan on adding a rarely used Garage Cassett. Do you have a Donation Link to your page?

Awesome video! I truly believe in neat and professional work. God bless, keep up the great work!

EXCELLENT video..

I have 5 of these cassettes installed for about 4/5 yrs. They are very efficient. But I do wish the 4 way cassette was designed to fit between joist. I understand they have the feature to allow a vent to be branched off. This would be great for master baths. I also just think blowing air in 4 directions instead of one would be more efficient. Great video as always gentlemen.. 👏🏽👏🏽

The video didn't show you connecting the refrigerant lines to the cassettes. The first cassette in your video was in an open area so I'm curious how you hid the lines plus the condensate drain line.

Thank you for the video! How did you add the third head? Do you need to pump down the system, do a pressure test, and vacuum it again?

I'm not sure im asking the right questions, but..... did you use a special mini split ductless unit for indoor use. I alway thought they had to be placed outside. The one job you did where the home owner didn't want lines outside, so you ran them in the garage . Could he have put everything inside?

How small or should I ask how large of a room was the 6k unit installed. Including ceiling height

Do you prefer Oil on the threads of a flare fitting or Nylog?

Do you have a video series showing how to pressure tests and vacuum with a branch box installed

Does it read out actual room temperature anywhere?

Is there a certain setting on the branch box you need to use when you are pulling an evacuation or are all valves already opened up from factory?

Is there any Thermostat can be replaced with Mitsubishi Duct Spilt Wall 2 wire thermostat?

What brand of linehide do you use?

Do you have access to PVFY-P54NAMU-E1 thru your supply channel?

Thank you for the information. And thank you for answering some of the other questions. I had some of the same questions. Great Job!

Hello, What is this unit's model number? Thanks.

can you put this in a cathedral ceiling does insulation go over the unit? does it use room air as a source of air. will air come and go around or through the unit when not running. Does it heat and or just cool?

Show me the antenna effect in the installation guide use nylog all fittings with double flare and that High Press cost 3 Grand the more you Tinker with a plumbing it easier to leak Montgomery Scott

Thank you. All three units seem to blow air in the same direction. Could you please explain why it was done this way as opposed to pointinting the middle unit in the opposite direction. Thanks.

I have 5 ceiling cassettes, they look great. I absolutely didn’t want holes drilled into the sides of my home with lines run along it to the condenser. My 5 lines all come from 2 holes in the attic. I have one wall mounted separate unit in the basement.. All Mitsubishi. Love the system over conventional whole house HVAC..

How do you change the filter on these? Mine is having mildew smell for some reason and I didn’t know there’s filter up there other than the usual intake filter

Thank you! Good starting point to further research. I like ceiling cassette. In your opinion does the cassete moves the air efficiently in a large room? I have both daikin and mitsubishi. Daikin - 4 port unit, one wall mount unit had to be replaced within 3 years due to leak, otherwise i like it. Mitsubishi is 15k btu one to one wall mount with small outdoor unit, cools 20x50 area in less than an hour with fan set to only two bars :). I would be interesting to know if a comparable ceiling cassete unit will be able to do that.

Looks like a great job. Love my Mitsubishi Mini Split HVAC..

I have 5 MLZ Cassettes and never knew what the 1-2 lights meant. Thanks. Great system..

Hello, I am looking in getting a 5 zone Mitsubishi system with ceiling cassettes Between 1 way and 4 way, what is the main difference between the square 4 way and the rectangular ez-fit ceiling units and which one do you prefer?

Denver should have his own show! He's so funny! Tim Allen (Home Improvement) would be proud of him! He must keep you rolling with laughter - be careful if you are up a ladder with his jokes!

Great info! 😮 Looking to install a heat pump in Colorado in a cold climate on a new build. It’s about 1000 sqft 2bed 2bath. Would you have a recommendation for a system that could also use solar power to offset the cost of heating? Thanks!

If he couldn't rotate it he would have rotate it at all. Probably just didn't tighten it well. I agree with you that most contractors suck when comes to make it quality. I am installing myself Inverter system with new coil and new set of lines. Here is a. tip I came up with: I am putting 7/8 with 3/4 insulation copper line inside a 2.5" PVC pipe from Home Depot. Only where it exposed to outside. No need to mini split covers as they have gaps.

How would you heat and cool a restroom space?

wow you mentioned you just got to 2k subscribers at the end of this video, and now 11 months later you're at 16.5k subscribers! Thats awesome, keep up the good work! Anytime I have a question, or I am curious about the best way to install a ductless Mitsubishi unit this channel is the first place I go! I appreciate the knowledge! We are based out of South Shore MA👍

Sooooo….. how loud is it? Would be nice to know.

I have lg with branch box that needs to be charged, how do you charge past the branch box?

why is the cooling and heating capacity on the Mitsubishi - 24k BTU Cooling + Heating - M-Series H2i so much greater than the basic unit? were do you see the performance?

Why are the 6k units more expensive than the 9k units? Anyone notice the pricing is weird?