Видео

thanks, mine was very dirty but it also leak on the right side, the other vent. I am looking into that section- to see where it comes from. Water is cold.

The cover and diaphragm were both incredibly dirty. (We bought the house with the dishwasher) Thank you!

01 odyssey. At highway speed the van veers right when foot taken off accelerator. The steering wheel a actually ticks slightly left when this happens. Then the van corrects itself when accelerator is pressed again. And goes back to straight. There is tiny tie-rod play both sides. Tires have even wear. Van cluncks front left when accelerating after coming to a complete stop. Front and upper right motor mounts were just replaced. My nephew replaced both struts and springs about a month ago. Passrnger side vertical control arm bushing has some cracking. Van has 191,000 miles. All rubber suspension bushings were replaced at 135,000. Plus motor and tranny mounts.

Those Molex style batteries are everywhere! I first started buying these for my Hubsan X4 drone about 7 years ago. However, good luck charging them with a good r/c charger.

I would just like to thank you so much. You saved me from being impulsive and buying new dishwasher. Mine has been ripping water at the vent escape!!!!!!!! My grandpa found your video and I cleaned the diaphragm and instantly no leaking….. you guys please try this it works!!!!!!!!!! I will be doing this every few weeks thank you again

Wonderful video. I have cleaned the filter, inspected the seals, have taken it out to look for leaks, let it sit for weeks to dry out and nothing stopped the HEAVY indication or the leaks. This took about 15 minutes and last night, no leaks from the left side, AND no water spilling out when I open it in the morning from the steam vent. THANKS. I was very close to buying another one because of the frustration.

I had creaking, starting about a year ago, when turning at low speed and accelerating from a stop in a 2010 Odyssey (model year prior to that addressed by TSB 11-038). Greasing the top of the front struts resolved it. I'm surprised that the strut bump stops are in contact with the top of the strut body. Maybe that happens as the springs age and sag a bit? I used Honda Shin Etsu silicone grease, as described in TSB 11-038. Any silicone grease is likely just as good, but this was a good excuse to get myself a tube of Honda's famed Shin Etsu silicone grease. p.s. I didn't check the strut nuts, there was no need, but I have had one loosen on another car and it produced a distict clunk noise that was nothing like the creaking noise caused by bump stops contacting the strut damper body.

Is this a joke? Like literally what's that supposed to do?

Thank you so much. We just sold our house and the same thing was happening here but thanks to your vid I was able to fix it in time! Thank you sir.

Great Video!

We need the audio lol

Hey I just did that to my after market shocks wish I gat OEM ALL READY TO JUST Switch MOOG 12 odyssey SWITCH

What! The wheel pivots left and right on two points, the lower ball joint and the strut bearing at the top of the spring. Its either one or the other part making noise while turning the wheel. Normally the strut bearing is bad if popping noise while turning. Look up bad strut bearing video to see spring binding and popping because of bad bearing.

This clip helped to solve my case which is 10 times worse under that round cover. My Samsung dishwasher is 9 years old and never got any cleaning or maintenance under that round area.

Having this problem with my dishwasher. Took the plate off and eww!!!, loaded with gunk. Even if it doesn't fix my leak (haven't run it yet) am glad to know how gross this area gets so I can keep on top of it

While accelerating here. Thanks! Other video on here said to take apart more stuff. Good to know this is easier and quick!! How about the back ones? Same?

You may need to tighten the front center nut on struts also there’s been issues with them coming un-torqued & it causes a popping sound also my 2011 Odyssey EX was lose on the drivers side.

I hope this solves the issue I was checking the bottom for leaks as the moisture sensor was being activated and could not find any issues other than dirt around the door. When I checked this location there was definitely build up. Running test now.

Hey bro what Kane of grease do you use for that shock

I have a different model, same problem tho. This 100% worked for me! Thanks for the video

Mine doesn't have the little black diaphragm part. When I take off that top plastic grill, it's just a white plastic piece under there.

I'm tired of fixing these Samsung's, maytag from here on out. Samsung breaks two months after warranty expires.

Amazing easy fix for a problem that has been plaguing me. We were about to give up and call for a certainly expensive tech visit.

Worked for DW80J3020US as well. We had the Heavy light blinking indicating a leak. Thanks very much!

Mine seams to be stuck down doesnt even come up so I'm gonna have to open the whole thing do you recommend to put a new rubber seal in .

Worked for us. It was all gunked up

Thank you

Thanks. This worked so far. Had to reassemble after repositioning to avoid massive leak and tighten screw just enough. But I'm so glad to know I don't need to buy a new dishwasher, which my husband was ready to do.

Boy I hope this is my problem. I'm 90% sure it is. I just check my dishwasher and it's exactly the same door guts. Yes it's a samsung. I'll do it tomorrow morning. Thank you

Nice and clear video! Thanks.

Thank you sir.

Doubted it.. but it was the fix! Thanks.. you saved me money and time! Still can't believe thats all it was. Awsomesause!!!

I've saved a small fortune knowing how to fix this. I've done this several times and it works every time. Thanks!

Thanks you very much .I follow you and I fix my dishwasher.

We had all our samsung appliances fail. Good tablets but for the mecanical department go with maytag

Thanks so much for your advice. I followed your instructions. So much gunk - gross! I hope it works. If not, I suspect it could be the rubber gasket along the bottom of the dishwasher door. I was wiping it to remove gunk and pieces of rubber broke off. I guess it has lost elasticity over the years and become brittle. There is now a gap along the bottom edge. I'm wondering if that rubber piece (different from the gasket along the sides and top) will need replacement? Happy Easter, folks.

Thank you! I just cleaned this based on your video! It was a mess and now I expect this will fix my issue! Never knew how this worked.

I am very glad I came upon this video after searching for a fix for my Samsung dishwasher (model DW80F600). Although I have run it once since doing your fix, it seems like it leaked more. I will give an update after I run it a second time as you suggested.

It’s also the steering knuckle by the gas pedals too you also need to grease that too here n there it’s annoying as the front struts are

Is there supposed to be any water going through the diaphragm or is it just steam?

Thanks Sadly it’s still leaking

You should’ve shown putting on the grease. Also what kind of grease did you use?

Tried this, didn’t work for me. If your Ody sounds like an old pirate ship with creaking at low speed turns it’s the drive axels and wasn’t too bad to fix.

You are my HERO! It worked like a charm!😁👍👍👍👍 Edit: is there a fix for the bottom right vents? Totally fixed leaks from the middle vents but the vents to the right let go a few drops

Thanks for the vedio, it worked! My Samsung dishwasher is a different model, but diaphragm part is the same. 🌹🌹👍

Would help to hear the sound you are talking about. I'm trying to diagnose sounds coming from my 2012 Oddysey

This was extremely helpful! Bought this unit new, never cleaned that out for four years. It was leaking pretty bad. This fixed it instantly! Also, good tip on making sure the fins are put back properly. Knowing my luck I would have put it on backwards if you hadn’t mentioned that. Thanks for the video. You tube actually can be useful, it’s just not full of trolls!

In a million years I would never had gone this route but my dishwasher had this very leak a few days ago and this fixed it. Thank you so very much, saved me a lot of headache and money!!!

That was it! You saved me a ton of time! Applies to DW80F600UTS as well

Thanks dude...you just saved me $250...