Видео

bro became a dot behind you homie :c

Where did you get the replacement part from if you don’t mind me asking ?

F80s on TEs are so sexy. I need one bad

Hey great video,! Jow far did you measure on the stock muffler to cut? I know AA is 1.5 inches after the "Y" section. Same with VRSF?

Hey what down pipe are you running?

Do you know the size of the tool you used to install it? Currently struggling to get it to seat flush

I hope you went back and figured out how to orient the ring so it matches the curve of the shift dome.........

Are you torqueing the the crank bolt without a flywheel holder?

I know damn well the thing down that he was on phone because autocorrect

Great video, that is a lot of work and requires a lot lf skill, many shops won't tackle a job like that and if they do they will charge way too much $$.

I have the same issue with mine. Have you found a solution to it yet ?

You have a voice of Papi Chulo 😂 Great video

Why you i been running ngk .22 and my car have idle low when i put it in stage 2

If you didn't have to wait over the weekend for parts to come, how long do you think it took to drop the tranny and remount it? 2 full days?

Wanna get this turbo！have you done your crankhub？

Great job 👏🏻

Can you tell me is the pops and bangs natural on the cooper no tune nothing because I want downpipe with that sound with my original decat do you suggest I do that to my cooper

Where you get that steering wheel

What camera set up you using?

what size lift do you have on?

I have the same issue, but having a hard time finding the same coil, most are 240VAC not 120VAC. Can you share where you got yours? Thanks!

your car is mean

love the content

The only thing tackier than that GTR plate was his spoiler. My gosh some kids just don't get it.

Whats the mic setup??? Sounds like im sittin on top the turbo.

Awsome car man 🔥🔥

Im bring my truck to the shop 😂😅

Nice!

Sounds bad Lmaoo sounds like a Honda straight pipe 🤣🤣

Wow #1 got dragged. Is that from a stuck injector?

Why you chose the rear right back door comfort hand ? How about if it's another door hand how you know? Any answer please?

Looking like a true warrior. Good luck

LS3

Was it making a noise

Have you gone e30 yet? Should do 600

Would a c300 engine work in a c350?

that makes no sense. I made 500whp w stage 1 and intakes. 550whp with stage 2, dp, and intakes.

Its gonna be alll worth it once finished. Keep Pushing General.

May your journey treat you well

That engine looks pretty good internally still. Nice

Such a feminine car

Nice work when I did my I didn’t bother taking out coils

@Jbp garage where did u buy your engine at? Or is there a website that i can go on Cause i have recent blew my motor out i drive a 2009 Toyota Yaris as well

🤙

I think over 4 min of you cleaning at the start so you can stretch to the 10 min mark for a video that could have been 60 seconds makes you a waste of time

Is better in a roll for the anti lagg

5:48 "I think i might get a ticket guys", drives through stop sign.

Awesome job! Which clear coat brand did you use?

Excellent job! One question - you were able to manually rotate engine with dct left in P?

Red RTV gasket maker to reseal the trans pan?