Видео 30
Просмотров 118 113

Power steering line removal and install 1st Gen Toyota Tundra

13:37

1st Gen Toyota Tundra Driveshaft Carrier Bearing install

12:38

37in Tire Fitment 1st Gen Tundra Pt 2 (update)

4:11

Radiator Coolant Flush Toyota Tacoma 1996-2004

13:51

Spark plug and coil pack replacement 1st Gen Toyota Tundra

7:44

OG Dirtbaggarage 4Runner walk around presented by Eric

30:58

ARB Front Air Locker switch and airline install

This is a video I filmed back when I wired the switch and completed the air plumbing on my ARB front locker
This was done on a 2000 Toyota Tundra but the process should be similar to any ARB locker install.
This required some customization and cutting so really think about your set up and own application before attempting.
I also had a wire crossed and would’ve discovered it if I tested the engagement after install. I rechecked my work and the locker actuated just fine.
Supplies needed were provided in a kit with the front locker but I’ll list them below
ARB air locker line
ARB banjo fitting and washers
ARB quick disconnect fitting
ARB locker solenoid
ARB Front locker switch

Видео

Power steering line removal and install 1st Gen Toyota Tundra

13:37

Power steering line removal and install 1st Gen Toyota Tundra

Просмотров 230Месяц назад

In this video I replace some leaking power steering lines that bled over my passenger side rack bushing destroying it. I opted to buy a complete set from oreillys below www.oreillyauto.com/detail/c/import-direct-power-steering/chassis steering/power-steering/steering-hose-assembly pressure-line/8511739221af/import-direct-p-s-pressure-and-return-line-hose-assembly/ops0/13401256/v/a/8199/automoti...

1st Gen Toyota Tundra Driveshaft Carrier Bearing install

12:38

1st Gen Toyota Tundra Driveshaft Carrier Bearing install

Просмотров 1,3 тыс.3 месяца назад

This video goes over the removal and install of the driveshaft carrier bearing also known as a center support bearing for a 2000 Toyota Tundra. This process should similar or the same for Toyotas with this style of carrier bearing for the driveshaft. BEARING Dorman Driveshaft Center Support 934-401 From autozone You’ll need A jack stand to support the driveshaft Flathead screwdriver Prybar 14mm...

37in Tire Fitment 1st Gen Tundra Pt 2 (update)

4:11

37in Tire Fitment 1st Gen Tundra Pt 2 (update)

Просмотров 6024 месяца назад

This is the update following the 37 inch tire fitment video on my 2000 Toyota Tundra. ruclips.net/video/kFxOpzpn-zY/видео.html Reevaluated my wheel and tire set up after blowing up my front differential at Sand Hollow. Went from Beadlocks and Nittos to SSW and Mickey Thompson Baja Legend EXP. Set ups and weights as follows: Beadlocks 45lbs Nittos 78lbs=123lbs per corner SSW 26lbs Nittos 78lbs=1...

Radiator Coolant Flush Toyota Tacoma 1996-2004

13:51

Radiator Coolant Flush Toyota Tacoma 1996-2004

Просмотров 3,2 тыс.5 месяцев назад

This video goes over the steps to complete a Radiator coolant flush and a thermostat replacement on a 1997 Toyota Tacoma. This process should be the same for Tacomas 1996-2004 or Toyotas equipped with the 5VZ-FE V6 engine. I completed a total of 3 flushes prior to filling the truck with Toyota coolant but it would probably have required about 5-6 flushes for the fluid running through the radiat...

Spark plug and coil pack replacement 1st Gen Toyota Tundra

7:44

Spark plug and coil pack replacement 1st Gen Toyota Tundra

Просмотров 1,5 тыс.8 месяцев назад

This video goes over how to remove and replace the spark plugs and coil packs on a 2000 Toyota Tundra. This is for the 2UZ FE motor and should be the same or similar for Toyota Tundras 2000-2006. This motor is also found in 4th Gen 4Runners. Spark plugs and coil packs are from Autozone and have not given me any issues. Motor runs great! Tools needed: 5/8 spark plug socket Long 3/8 extension 3/8...

OG Dirtbaggarage 4Runner walk around presented by Eric

30:58

OG Dirtbaggarage 4Runner walk around presented by Eric

Просмотров 2628 месяцев назад

In this video we have one of our OG Dirtbag garage members ERIC go over some of the many features on his rig a 2000 Toyota 4Runner. This particular rig has seen many trails already including Calico (Odessa loop), Moab (pickle trail, cliffhanger, hells revenge, poison spider), big bear (Holcomb) and many more to come. Instagram: @thedirtbaggarage @yotq.ericg @dr_omiz

37 Inch Tire Fitment 1st Gen Toyota Tundra

15:18

37 Inch Tire Fitment 1st Gen Toyota Tundra

Просмотров 6 тыс.11 месяцев назад

This video walks you through some of the steps I took to fit 37 inch tires on a 2000 Toyota Tundra. This should be similar for most Toyotas if you are willing to do some cutting. Please note that I already had a much of the firewall cut away and tubbed the wheel well prior to this video. IMPORTANT To properly fit 35 inch tires and beyond you will need to have a cab mount chop or relocation and ...

1st Gen Toyota Tundra Complete Mid-travel install

27:43

1st Gen Toyota Tundra Complete Mid-travel install

Просмотров 5 тыс.Год назад

In this video I walk through a full mid travel install on a 2000 Toyota Tundra This will be applicable for 2000-2002 Tundra and similar or the same for 2003-2006 Mid travel install includes: Solo Motorsports Lower Control Arms KP offroad cam bolt and cam plate kit Fox 2.5 coilovers Factory performance Total Chaos Upper Control Arms Custom uniball Lower ball joint Custom heim joint steering VIDE...

11:35

FOX 2.5 Coilover preload adjustment

Просмотров 8 тыс.Год назад

Preload adjustment on FOX 2.5 coilovers factory race series. Part#880-06-420 for Toyota Tundras 2000-2006 but should be similar for all FOX 2.5 Coilovers From my search on forums 1/2” of preload roughly measures out to 1” of height increase. I increased the preload to 1 1/4” of preload roughly 2.5 inches of height increase. ATTEMPT THIS AT YOUR OWN RISK. THIS IS ONLY A GUIDE AND NOT PROFESSIONA...

2000 Toyota Tundra walk around and build plan Pt3

6:02

2000 Toyota Tundra walk around and build plan Pt3

Просмотров 2 тыс.Год назад

Here’s an update on the 1st Gen Tundra. Still on 35s, regeared, rear locker but now on a Total Chaos Long Travel Kit The kit adds 3.5 width to each side brining it to about 86in in track width. Also upgraded to heim joint steering with a custom lower ball joint. Full video of that install can be found here LONG TRAVEL INSTALL ruclips.net/video/96Bs1OrnqSo/видео.html Other video of the brake boo...

6:34

SDHQ Battery Terminal Upgrade Install

Просмотров 1,7 тыс.Год назад

SDHQ battery terminal upgrade 02-3003-C2 install Done on a 1st generation Toyota Tundra but should be applicable to most vehicles. Install took about 20-30min with proper tools. SDHQ: sdhqoffroad.com/products/sdhq-built-complete-billet-battery-terminal-kit TEMCO Crimper: www.amazon.com/TEMCo-Hammer-Crimper-Tool-Warranty/dp/B00E1UUVT0/ref=asc_df_B00E1UUVT0/?tag=hyprod-20&linkCode=df0&hvadid=30...

5:59

Headlight upgrade 1st Gen Toyota Tacoma

Просмотров 2,1 тыс.Год назад

First must do mod on my 1997 Toyota Tacoma. This is an LED headlight upgrade featuring some Amazon lights that are pretty impressive in quality for the price. Easy install, plug and play no splicing or soldering needed. Amazon links to parts: LED headlights www.amazon.com/gp/aw/d/B08VD6PQPH/ref=ya_aw_od_pi?ie=UTF8&psc=1 Headlight relay www.amazon.com/gp/aw/d/B08NDC5TQX/ref=ya_aw_od_pi?ie=UTF8&p...

Cheap Wiper Tank Relocation 1st Gen Toyotas

4:55

Cheap Wiper Tank Relocation 1st Gen Toyotas

Просмотров 1,5 тыс.Год назад

Installed a 1996 Toyota Tacoma wiper tank into a 1st Gen Toyota Tundra. Relocated the tank in the engine bay using the same sensor/motor in the new tank. Leave a comment for questions Follow @thedirtbaggarage and @dr_omiz on IG

1st Gen Tundra cruising through Calico Odessa Trail

8:42

1st Gen Tundra cruising through Calico Odessa Trail

Просмотров 2,3 тыс.Год назад

Vid of my 1st Gen Toyota Tundra cruising through Odessa canyon trail in Calico. Tundra is equipped with 35s, 4.88 gears, rear locker and Total Chaos Long Travel kit. LT kit brings the track width to about 76/77 inches. I was also accompanied by my off-roading crew Thedirtbaggarage. Only section I had trouble with was the waterfall which unfortunately had water and mud at the bottom. A little te...