Видео

Here is a tour of my service call bag. Hope someone is able to get som use out this video. Sorry for the NCV rant. I really can’t stand there inclusion on seeming any electrical tool these days

Here is a tour of my boxes and my shop. Lots of variety. Cornwell power drawer cart, US General boxes. I have quite a bit of stuff for electrical diagnostics in both vehicles and heavy equipment.

This is the final update before I move to my new shop and larger box

Hers a quick vid I did with my M18 1/2” impact. This thing has been great and I’m always trying to find something that it can’t do. It finally meet its match today removing cutting edge bolts and nuts. To be fair it removed 21 out of 22 on a single battery with no trouble. I ended up torching the one that was stuck rather than lugging out the 1” impact. This is a job that is typically done with...

Here's the unboxing vid where I give my initial impressions. So far I really like it. I've had a chance to use it and it's a significant upgrade for me. It's stronger and quieter than my old gun. I say that I will do this as a full review but I haven't gotten around to it yet so I'll post this as a initial review. Thanks for watching

Heres a tour of my box. Its a crappy 44" Harbor Freight thats busting at the seams with tools. Its been a good box but its too small. Hope you enjoy watching my tour.

Here's a quick way to repair the thin and crappy nylon fuel nipple in the bottom of the tank. This should be applicable on any L series tractor

Here's a quick video about timing cover failure where I show the failed housing and explain how I diagnosed this issue. Sorry for all the umms and ahhs. Did this one off the cuff.

Here's how I remove injector cups without the special tool. This method could be used with heads on the vehicle, it will just take some creative maneuvering. I would also put something at the bottom of the cup to prevent chips from getting into the cylinders as Dieseltech Ron recommends. Do this at your own risk and obey common shop safety practices. Thanks, please like if this helps you.

Durgo Knives is the company of Bladesmith Matthew Durgo. For more info check us out at Durgoknives

New Project 1

Rally on 2-28-13 Dont believe the media, there were 10,000 people in attendance

Square threadwheel skimmer using a bubbleplate and a recirc pump. System is counter-current with a top feed valve.

We had the courtyard filled. The state run media refused to cover us....United We Stand

Kylie and friends tubing

Surge Video 1

DIY Threadwheel Skimmer

Aquascape Party v.2

Flow video

fishtank video HQ

Fishtank