Видео

Follow us on Facebook.com/TPRacin

Ride along with us in the TJay Pratt 712 Racing Factory stock in the 2023 Factory Stock Heat 3. We had a good qualifying lap which set fastest time in our (2nd)group and 4th overall out of 37 cars. We started P1 in the 3rd heat and led every lap which locked us in on the outside pole position in the A main. We ended up with a DNF in the feature after falling back to P5 11 laps in. A caution cam...

Follow us on Facebook.com/TPRacin

We started P4 in the 2nd heat and finished P2 which gave us a P4 start in the feature and finished P2. Follow us on Facebook.com/TPRacin

Here is our night at Outlaw Speedway in Perkinston Ms. Started P5 in the heat, finished P2. Started P3 in the 11 car feature and finished P2. Follow us on Facebook.com/TPRacin

Take a ride with the 712 factory stock at Outlaw Speedway in Perkinston Ms. After a wreck in the heat race gave us a rear starting spot in the feature, we where able dig hard and salvage a P3 finish in the feature. Follow us on Facebook.com/TPRacin

This is a cheap and easy fix on a 2006 Mercury 25 4 stroke EFI that has a bad ECM. This ECU lost power from the ground source to the fuel pump. It happened shortly after an aftermarket (Quantum) fuel pump was installed.

10/28/22 Pure Street Heat 3. Started pole of 7 car heat and finished p1

Take a ride in T’Jay Pratt 712 Racing’s pure stock at Hattiesburg Speedway. This was the last race of the season for this track. We started pole for the heat race and won it. That gave us P3 start for the feature. We ran P3 the entire feature race but had a driver mess up and then lap traffic on the last lap and fell back to a P4 finish. Follow us on Facebook/TPRacin

Ride along with us for our Pure Street Feature on night 1 of the Fall Brawl at Hattiesburg Speedway. We started last (P16) due to breaking a tie rod in the heat resulting in a DNF. We dug our way up to a P2 finish and ended up winning the “Highest Average Finisher” award after a P3 finish on the 2nd night. Follow us on FB @ #TPRacin TJay Pratt Racing #712

Take a ride and endure our bad luck with us as we loose another Top 3 run. We started 4th. Car didn't like the characterized track and we fought tightness all night. Fell back to as far as 6th before the issue but was running 3rd when we had to go to the rear. Ended up with an 8th place finish. Follow us on Facebook @ TPRacin

You can save over $500 by just replacing your brushes inside your trim motor vs an entire trim motor replacement. Watch how it’s done and some tips and tricks to make your job smoother. This 2016 Suzuki DF150 has almost 3000 hours on it and used on a commercial crab boat. It gets abused and worked! This same trim motor is on all of the Suzuki DF60 - DF300 and some DT motors.

This is a 2001 Ford F350 dually ( Drw ) that had a bad driveshaft support / carrier bearing that caused the pinion seal to start leaking.

Kioti Nx assembly after splitting

GOOD OR BAD LUCK?? Kioti NX split to fix oil leak

2010 - 2012 Nissan Altima Headlight Replacement

2008 f250 6.4 powerstroke a/c compressor replacement

OUTLAW SPEEDWAY (MS) FACTORY STOCK FEATURE

OUTLAW SPEEDWAY (MS) FACTORY STOCK HEAT

OUTLAW SPEEDWAY FACTORY STOCK HEAT 05 14 22

Outlaw Speedway Feature Race 05/14/22

Factory Stock Racing at Outlaw Speedway

HATTIESBURG SPEEDWAY PURE STREET FEATURE 3-25-22

Hattiesburg Speedway Pure Street Feature

Outlaw Speedway Factory Stock 09 11 21 feature

Outlaw Speedway Factory Stock 09 11 21 heat

Hattiesburg Speedway Pure Street Feature 08 14 21

Outlaw Speedway Factory stock Feature 06 13 21

Feature Deep south speedway factory stock 6 27 21