Видео

I was wondering why my cone won’t come off. I’ll try it tomorrow. All nuts are off but cone wasn’t coming off. Thanks for the video!

good video!. I'm currently rebuilding a 3 rib with a new 4:13 pinion and original gears. You mention pressing 3rd gear in place if original, I imagine the same tips are good for the 3 rib? ... or could mill down the splines lightly and have the gears slide on without pressing.

How much tonnage do you need to do this work? (Hydraulic press only or will a 1 ton arbor press work?) Thank you.

Hi Tim, Thanks for your videos. I have a question before I purchase you book, is there information in your book on any modifications to make the transaxles work more smoothly and accurately? (hop-ups, etc?) Thank you.

Great videos Tim! I hope you don’t mind, but I gave a shout-out to your transaxle book on my latest video. It’s an awesome work of information, so I figured I’d give credit where credit is due. Thanks!

Very helpful

Oh great and i thought I could do it myself

Very nice. Exactly what I needed to see. Thanks!

Can you repair the part that you pointed out is corroded? I haven't taken my nose cone off yet but I am almost positive I have the same problem

Can you make a video on a 091 dropping the gear set into the case to see how not to struggle dropping that darn reverse gear 😂

Great vidoe's, do you offer a transaxle rebuild service? I have a 1978 091 that needs to be gone through. Thanks

Can I get a parts list aftermarket part

any chance of getting a parts list what aftermarket gears and ring the opinion parts you would need to do what you're building is it in your book

In your book I couldn't find if if the ring opinion on a 002 the same as 091

if you were anywhere near western ma. i'd be glad to bring you my trans and pay you to do yer magic, so i dont have to try it myself and end up with a floor full of parts...

Looks like I found my new transaxle man where are you located

Does that mean those parts will go into the web HV1 case

Thank you.

how about the seal at the end ,,,,?

Should there be a rubber bushing or cover or something on the shaft of the hockey stick, where it goes into the nose cone to prevent dirt and water from entering the nose cone. Thanks.

Thats the way they come from weddle.

Do more video

Thanks for making these

Them is some clean parts! How did you get them so clean?

good trick.

Is there going to be a video later of the o91 jig?

BFH! :)

thanks for posting this.